- Uploader sends 'FLASH <baud>' first; the ESP32 restarts the Nano and
bridges at that baud rate, then answers OK
- --baud=auto (default) tries 57600 (old ATmegaBOOT) then 115200 (Optiboot)
- Optional nano_reset GPIO (NPN to Nano RESET) pulses reset after power
on, needed for Optiboot which skips the bootloader after a power cycle
- Clear errors for outdated ESP32 firmware and missing wires
- README: bootloader table, reset wire, troubleshooting
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- ESP32: NanoFlashBridge on TCP port 2323. A connection power cycles the
Nano into its bootloader and bridges TCP <-> Serial2 at 57600 baud; the
clock pauses during the session, 10 s idle timeout
- tools/nano_net_upload.py: STK500v1 uploader over TCP (standard library
only), with sync retries, write and read-back verification. avrdude 6.3
net: ports are broken on Windows, so avrdude is not used
- New nano_ota environment: pio run -e nano_ota -t upload
- README: usage, requirements, troubleshooting; TODO for hardware test
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
mangavalkandClaude Opus 5.5