Structure (src/esp32/):
- logic/: DisplayController, schedule, power timer, LED pattern; pure C++
- display/: FlipdotFrames and bitmaps
- nano_link/: NanoLink (relay, serial, READY, bootloader) and flash bridge
- net/: WiFi/OTA/panic window, Home Assistant
- config.h with all settings; libs.h (globals in a header) removed
Bug fixes:
- Home Assistant switches now report their state back and start as ON
- loop() no longer blocks: WiFi.waitForConnectResult() (up to 60 s
without WiFi) and getLocalTime() (5 s before NTP sync) were called
every iteration
- Power switch off now powers off after 1 s even when a 30 s countdown
is already running
- millis() overflow safe power-off timer; no frame catch-up bursts
- No garbage time string before NTP sync; 'Connecting...' stays instead
- Frames are only sent when the screen changes instead of every second
- Reset reasons are logged once instead of every 100 ms
- Removed dead code (unused fonts, WiFiMulti, rotated bitmap, ...)
Tests: new test_esp32 environment (26 tests); native renamed to test_nano
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Uploader sends 'FLASH <baud>' first; the ESP32 restarts the Nano and
bridges at that baud rate, then answers OK
- --baud=auto (default) tries 57600 (old ATmegaBOOT) then 115200 (Optiboot)
- Optional nano_reset GPIO (NPN to Nano RESET) pulses reset after power
on, needed for Optiboot which skips the bootloader after a power cycle
- Clear errors for outdated ESP32 firmware and missing wires
- README: bootloader table, reset wire, troubleshooting
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- ESP32: NanoFlashBridge on TCP port 2323. A connection power cycles the
Nano into its bootloader and bridges TCP <-> Serial2 at 57600 baud; the
clock pauses during the session, 10 s idle timeout
- tools/nano_net_upload.py: STK500v1 uploader over TCP (standard library
only), with sync retries, write and read-back verification. avrdude 6.3
net: ports are broken on Windows, so avrdude is not used
- New nano_ota environment: pio run -e nano_ota -t upload
- README: usage, requirements, troubleshooting; TODO for hardware test
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- New native environment: pio test -e native
- test/mocks: fake Arduino core, EEPROM and recording BROSE9323 driver
- test/test_nano: 25 tests covering every command, bitmaps, bad input,
flip time storage and the periodic full redraw
- Board environments ignore tests so they are never uploaded
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Shared BROSE9323 driver in lib/, ESPSERIAL selected via build_flags
- Nano firmware in src/nano, ESP32 firmware in src/esp32
- Move WiFi/MQTT credentials to gitignored secrets.h (template provided)
- Pin home-assistant-integration to 2.1.0 from the registry
- Add esp32_usb environment for first flash / recovery
- Add READMEs and CLAUDE.md
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
mangavalkandClaude Opus 5.5