mangavalkandClaude Opus 5.5
eaf9c82617
- Split the macro files into folders by topic (print, heating, afc, pressure_advance, spoolman, leds, sensors); klipper-macros.cfg is the one file printer.cfg includes. Macros moved unchanged; the effective config is identical apart from the paths of the PA shell scripts. - Add the modified Blobifier (Turtleblobifier for AFC) and define [save_variables] once in save_variables.cfg instead of in both blobifier.cfg and the PA macros (same file, bd_pa_variables.cfg). - PRINT_WARMUP: heat to the loaded lane's temperature before the first tool change. AFC skips heating when the loaded lane's tool number is not in the print file's temperature list, and the unload then failed below min_extrude_temp. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
27 lines
894 B
INI
27 lines
894 B
INI
##########################################################################################
|
|
# The servo hardware configuration. Change the values to your needs.
|
|
#
|
|
[servo blobifier]
|
|
# Pin for the servo.
|
|
pin: PC1
|
|
# Adjust this value until a 'BLOBIFIER_SERVO POS=in' retracts the tray fully without a
|
|
# buzzing sound
|
|
minimum_pulse_width: 0.00053
|
|
# Adjust this value until a 'BLOBIFIER_SERVO POS=out' extends the tray fully without a
|
|
# buzzing sound
|
|
maximum_pulse_width: 0.0023
|
|
# Leave this value at 180
|
|
maximum_servo_angle: 180
|
|
|
|
##########################################################################################
|
|
# The bucket hardware configuration. Change the pin to whatever pin you've connected the
|
|
# switch to.
|
|
#
|
|
[gcode_button bucket]
|
|
pin: ^PC3 # The pullup ( ^ ) is important here.
|
|
press_gcode:
|
|
M117 bucket installed
|
|
release_gcode:
|
|
M117 bucket removed
|
|
_BLOBIFIER_COUNT_RESET
|