mangavalkandClaude Opus 5.5
e5be65834e
The motion timeout switched the nozzle LEDs off during prints, motion switched them off when idle or paused, the timeout counted from the first movement, and every _status_* macro stopped the nozzle light. - _LIGHTS sets case light and nozzle LEDs from presence, print state and CASELIGHT MODE=AUTO|ON|OFF; the timeout (60 s) starts at the sensor release - _STATUS STATE=... replaces the _status_* macros; logo effects only cover the logo LEDs and use REPLACE=1 - heater gauge while heating, print progress, paused, error flash from _ERROR, part ready once the bed is cool, dim night mode when idle and nobody near, cleaning during BLOBIFIER_CLEAN - removed unused effects and macros, 12 fps for the toolhead effects Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
24 lines
647 B
INI
24 lines
647 B
INI
# Idle timeout: heaters and motors off when the printer is idle
|
|
|
|
# [dynamicmacros]
|
|
# configs: Macros/dynamicmacros.cfg
|
|
|
|
# [gcode_button kill_switch]
|
|
# pin: gpio7
|
|
# press_gcode: M112
|
|
|
|
[idle_timeout]
|
|
gcode:
|
|
TURN_OFF_HEATERS
|
|
iHEATER_OFF ; Turns off the chamber heater
|
|
M84
|
|
# reset paused flag
|
|
{% if printer.pause_resume.is_paused|lower == 'false' and park|lower == 'true'%}
|
|
_TOOLHEAD_PARK_PAUSE_CANCEL
|
|
{% endif %}
|
|
_STATUS STATE=ready
|
|
# A list of G-Code commands to execute on an idle timeout. See
|
|
# docs/Command_Templates.md for G-Code format. The default is to run
|
|
# "TURN_OFF_HEATERS" and "M84".
|
|
timeout: 85400 # 24 hours
|