aldis (https://github.com/mjonuschat/aldis, GPL-3.0) replaces
scripts/update_all_mcus.sh: it discovers the MCUs from Moonraker and builds
and flashes only outdated ones with the Kconfig each MCU reports. Its source
is a submodule in external/aldis pinned to v0.4.0, the release installed on
the Pi in ~/aldis (Moonraker does not fetch submodules, so it stays empty
there). The old script moves to scripts/archive/; the Katapult script stays,
aldis does not update bootloaders. scripts/README.md: install, setup, use
and the checks for this printer (all MCUs report mcu_kconfig, all use
Katapult). README and CLAUDE.md point to it.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Plastic left on the nozzle sets the contact Z too high and squeezes away
during the run. The first real Verify (2026-11-04, about an hour after a PLA
print) saw bd_pressure and Beacon contact sink by about 0.004 mm per point
while proximity held within 0.006 mm, so it asked for a re-run. That cause
is likely but not yet confirmed.
Same order as PRINT_START: QGL, G28 Z, BLOBIFIER_CLEAN with the guard in log
mode, then the contact step. Refuses to start without BLOBIFIER_CLEAN or
_GUARD_ON. Tested against the simulated printer only.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A closed terminal made print() raise and any unexpected exception skipped the
cleanup, leaving the nozzle low and hot. Both now end in the normal stop.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
scripts/twist_check.py runs on the Pi and measures or verifies the nozzle vs
Beacon offset; windows explain each step, show progress and give a verdict,
with an HTML report in config/twist_data/. It refuses to start during a print,
stops on unexpected readings and never changes printer.cfg.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- bd_pa_spoolman.cfg renames AFC's SET_SPOOL_ID, so klipper-macros.cfg
must be included after [include AFC/*.cfg]; the README said otherwise.
- install.sh links scripts/ as ~/printer_data/config/klipper-macros-scripts
so the scripts can be edited in Mainsail/Fluidd.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Macros as they run on the printer (Voron 2.4 + AFC Box Turtle +
Blobifier + Beacon + bd_pressure + bdwidth + iHeater), the Klipper
modules they need (xy_drift, bdwidth_status, bdpressure_check), MCU
firmware update scripts, install.sh with Moonraker update manager
support, and READMEs.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>