Plastic left on the nozzle sets the contact Z too high and squeezes away
during the run. The first real Verify (2026-11-04, about an hour after a PLA
print) saw bd_pressure and Beacon contact sink by about 0.004 mm per point
while proximity held within 0.006 mm, so it asked for a re-run. That cause
is likely but not yet confirmed.
Same order as PRINT_START: QGL, G28 Z, BLOBIFIER_CLEAN with the guard in log
mode, then the contact step. Refuses to start without BLOBIFIER_CLEAN or
_GUARD_ON. Tested against the simulated printer only.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A closed terminal made print() raise and any unexpected exception skipped the
cleanup, leaving the nozzle low and hot. Both now end in the normal stop.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
scripts/twist_check.py runs on the Pi and measures or verifies the nozzle vs
Beacon offset; windows explain each step, show progress and give a verdict,
with an HTML report in config/twist_data/. It refuses to start during a print,
stops on unexpected readings and never changes printer.cfg.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>