A CLOG DETECTED pause is usually a real blockage: on 2026-11-17 a nozzle
blocked right after a swap, the purge check passed (a blocked nozzle also
builds pressure) and the automatic resume only printed air until the next
CLOG pause. CLOG messages are still cleared after a resume, so a leftover
one cannot hide the next NOT FEEDING message.
The purge check now also fails when bd_pressure's delta is still above
pressure_max_delta (15) when the check stops: 16 good purges -3..+10, two
long purges into the blocked nozzle +19/+21 (the short ones did not show it).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A NOT FEEDING / CLOG pause during a print runs RESUME by itself after 5 s,
so the lane check and the purge check decide; a failed check keeps the print
paused. At most 2 per print, none within 10 min of printing of the previous
one, only between _PRINT_START_FINISH and the print end.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>