Commit Graph
2 Commits
Author SHA1 Message Date
mangavalkandClaude Opus 5.5 1fc4b26366 TWIST_CALIBRATE: wipe the nozzle before the contact step
Plastic left on the nozzle sets the contact Z too high and squeezes away
during the run. The first real Verify (2026-11-04, about an hour after a PLA
print) saw bd_pressure and Beacon contact sink by about 0.004 mm per point
while proximity held within 0.006 mm, so it asked for a re-run. That cause
is likely but not yet confirmed.

Same order as PRINT_START: QGL, G28 Z, BLOBIFIER_CLEAN with the guard in log
mode, then the contact step. Refuses to start without BLOBIFIER_CLEAN or
_GUARD_ON. Tested against the simulated printer only.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-04 00:47:04 +01:00
mangavalkandClaude Opus 5.5 7bee9a1ecd Add a user guide for the axis twist calibration
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-03 22:55:55 +01:00