TWIST_CALIBRATE: wipe the nozzle before the contact step
Plastic left on the nozzle sets the contact Z too high and squeezes away during the run. The first real Verify (2026-11-04, about an hour after a PLA print) saw bd_pressure and Beacon contact sink by about 0.004 mm per point while proximity held within 0.006 mm, so it asked for a re-run. That cause is likely but not yet confirmed. Same order as PRINT_START: QGL, G28 Z, BLOBIFIER_CLEAN with the guard in log mode, then the contact step. Refuses to start without BLOBIFIER_CLEAN or _GUARD_ON. Tested against the simulated printer only. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
7bee9a1ecd
commit
1fc4b26366
3 files changed
+14
-5
No files matched your search
@@ -42,8 +42,8 @@ The calibration clears the active bed mesh (saved profiles stay).
|
||||
|
||||
## What the run does
|
||||
|
||||
It heats the nozzle to 150 C, homes, runs QGL and sets Z by contact. It then
|
||||
visits each point twice, the second pass in reverse order to cancel slow drift.
|
||||
It heats the nozzle to 150 C, homes, runs QGL, wipes the nozzle on the Blobifier
|
||||
brush and sets Z by contact. It then visits each point twice, the second pass in reverse order to cancel slow drift.
|
||||
The nozzle touches the bed at every point. At the end it lifts to Z10 and turns
|
||||
the nozzle heater off. The bed heater is not touched.
|
||||
|
||||
@@ -140,6 +140,7 @@ that computer, under its own home directory.
|
||||
- Mainsail with `[respond]`, for the windows
|
||||
- `gcode_shell_command`, to start the script from a macro
|
||||
- Beacon, used in contact and proximity mode
|
||||
- The Blobifier macros (`BLOBIFIER_CLEAN`) and the nozzle guard (`_GUARD_ON`)
|
||||
- Python 3 on the Pi (standard library only), and Moonraker trusting localhost
|
||||
- For Verify: `[bdp_touch]` and the bd_pressure load-check firmware
|
||||
- `[axis_twist_compensation]` is not needed for the first Measure; the result
|
||||
|
||||
Reference in new issue
Block a user