TWIST_CALIBRATE: wipe the nozzle before the contact step

Plastic left on the nozzle sets the contact Z too high and squeezes away
during the run. The first real Verify (2026-11-04, about an hour after a PLA
print) saw bd_pressure and Beacon contact sink by about 0.004 mm per point
while proximity held within 0.006 mm, so it asked for a re-run. That cause
is likely but not yet confirmed.

Same order as PRINT_START: QGL, G28 Z, BLOBIFIER_CLEAN with the guard in log
mode, then the contact step. Refuses to start without BLOBIFIER_CLEAN or
_GUARD_ON. Tested against the simulated printer only.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-11-04 00:47:04 +01:00
1 parent 7bee9a1ecd
commit 1fc4b26366
3 files changed
+14 -5

No files matched your search

+1 -1
View File
@@ -80,7 +80,7 @@ gcode:
{% if bed > 40 %}
RESPOND TYPE=command MSG="action:prompt_text Note: the bed is at {bed|int} C. The reference runs were on a cold bed, so wait for it to cool unless you want this on purpose."
{% endif %}
RESPOND TYPE=command MSG="action:prompt_text It heats the nozzle to 150 C, homes, levels and takes {'25' if mode == 'measure' else '17'} minutes. The configuration is not changed."
RESPOND TYPE=command MSG="action:prompt_text It heats the nozzle to 150 C, homes, levels, wipes the nozzle on the brush and takes {'25' if mode == 'measure' else '17'} minutes. The configuration is not changed."
RESPOND TYPE=command MSG="action:prompt_footer_button Back|TWIST_CALIBRATE|secondary"
RESPOND TYPE=command MSG="action:prompt_footer_button All checked, start|_TWIST_START MODE={mode}|primary"
RESPOND TYPE=command MSG="action:prompt_show"