- Clock firmware: 'Connecting to WiFi...' and 'Getting the time...' at
boot, 'Crashed!' in the OTA-only modes, and 'No WiFi' with the time
when WiFi is down for over a minute (new DisplayController screen)
- Recovery app: shows its reason, the setup WiFi name, or its IP address,
then powers the display off (flipdots keep the image)
- StatusScreen and drawTextLines shared by both apps
- Driver: ESP begin() no longer draws 'ESP Connected'
- Tests: No WiFi screen, short reason texts (70 total)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- New flash layout (partitions.csv): factory = recovery app, ota_0/ota_1 =
clock firmware; esp32_usb uploads to ota_0 so it never overwrites it
- src/recovery: WiFi + OTA + web page only. Opens the password protected
'FlipDot-Setup' AP with a captive portal when WiFi fails, lets you pick
another WiFi (stored in NVS, used by both apps), start the clock or stay
- Recovery is started when the clock firmware can't connect to WiFi,
crashes 3 times, after 3 quick power cycles, from a new Home Assistant
button, or by the bootloader when no clock firmware works
- Shared NVS store and boot switching in src/esp32/system
- Clock firmware keeps working on the old flash layout (falls back to
OTA-only safe mode)
- README: recovery app, one-time USB installation; tests: 65 total
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Rollback: override verifyRollbackLater() so a new OTA image stays
pending until it ran 60 s with WiFi; any earlier restart rolls back
(the Arduino core marked every image valid at boot before)
- Task watchdog (30 s) on loop(), paused during OTA uploads
- Crash counter in RTC memory: OTA-only window after a crash, 10 min
safe mode (WiFi + OTA only) after 3 crashes in a row
- Restart when WiFi stays down for 10 min
- Home Assistant sensor 'FlipDot Display Firmware' with version/state
- logic/boot_policy with tests (60 tests total)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Structure (src/esp32/):
- logic/: DisplayController, schedule, power timer, LED pattern; pure C++
- display/: FlipdotFrames and bitmaps
- nano_link/: NanoLink (relay, serial, READY, bootloader) and flash bridge
- net/: WiFi/OTA/panic window, Home Assistant
- config.h with all settings; libs.h (globals in a header) removed
Bug fixes:
- Home Assistant switches now report their state back and start as ON
- loop() no longer blocks: WiFi.waitForConnectResult() (up to 60 s
without WiFi) and getLocalTime() (5 s before NTP sync) were called
every iteration
- Power switch off now powers off after 1 s even when a 30 s countdown
is already running
- millis() overflow safe power-off timer; no frame catch-up bursts
- No garbage time string before NTP sync; 'Connecting...' stays instead
- Frames are only sent when the screen changes instead of every second
- Reset reasons are logged once instead of every 100 ms
- Removed dead code (unused fonts, WiFiMulti, rotated bitmap, ...)
Tests: new test_esp32 environment (26 tests); native renamed to test_nano
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
mangavalkandClaude Opus 5.5