- ESP32 talks to the Nano on UART2 (GPIO 17 TX / GPIO 16 RX); Serial (USB)
is now free for debug output and boot messages no longer reach the Nano
- README: wiring table, actual schedule (clock from 08:00), TODO section
for the rewiring
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Nano / driver:
- No full on/off flip at boot; the first display() after boot is a forced
full redraw instead, since the physical dot state is unknown
- Send READY when booted
ESP32:
- relayOn() only switches and waits when the relay was off, and waits for
the Nano's READY (3 s timeout) instead of a fixed 3 s on every frame
- relayOff() ends Serial and releases the TX pin so the idle-high line no
longer back-powers the Nano through its RX pin
- No display commands are sent while the relay is off
- Switching the relay on cancels a pending power-off countdown
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Shared BROSE9323 driver in lib/, ESPSERIAL selected via build_flags
- Nano firmware in src/nano, ESP32 firmware in src/esp32
- Move WiFi/MQTT credentials to gitignored secrets.h (template provided)
- Pin home-assistant-integration to 2.1.0 from the registry
- Add esp32_usb environment for first flash / recovery
- Add READMEs and CLAUDE.md
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
mangavalkandClaude Opus 5.5