- Web UI on port 80: live view of the display, choose the page (clock or
a bitmap), bitmaps (list, show, live, edit, delete), draw / image upload
with conversion in the browser, live mode, settings, Home Assistant
- Live view from a shadow buffer in the BROSE9323 driver (shownPixel)
- Settings in NVS with the original behaviour as defaults: schedule times,
quarter hours, yawning Pikachu, No WiFi screen, flip time, status LED,
Home Assistant broker (restart on change)
- Bitmaps on LittleFS; new 320 KB partition, ota slots now 1.31 MB
- DisplayController: pages, live mode, settings; app.cpp holds the objects
- README for the recovery app; docs for the web UI
- Tests: settings, time parsing, bitmap format and names, schedule with
settings, pages and live mode (95 total)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Clock firmware: 'Connecting to WiFi...' and 'Getting the time...' at
boot, 'Crashed!' in the OTA-only modes, and 'No WiFi' with the time
when WiFi is down for over a minute (new DisplayController screen)
- Recovery app: shows its reason, the setup WiFi name, or its IP address,
then powers the display off (flipdots keep the image)
- StatusScreen and drawTextLines shared by both apps
- Driver: ESP begin() no longer draws 'ESP Connected'
- Tests: No WiFi screen, short reason texts (70 total)
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Nano / driver:
- No full on/off flip at boot; the first display() after boot is a forced
full redraw instead, since the physical dot state is unknown
- Send READY when booted
ESP32:
- relayOn() only switches and waits when the relay was off, and waits for
the Nano's READY (3 s timeout) instead of a fixed 3 s on every frame
- relayOff() ends Serial and releases the TX pin so the idle-high line no
longer back-powers the Nano through its RX pin
- No display commands are sent while the relay is off
- Switching the relay on cancels a pending power-off countdown
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Commands run on '\n' instead of busy-waiting for a byte count, which
fixes s/F/T waiting for the next command and P drawing 0xFF garbage
- Invalid bitmaps no longer leak their data as commands; bitmap data is
streamed so full-screen bitmaps still fit
- Store flip time as uint16 with magic marker, validate 50-2000 us
- Overflow-safe millis() handling for the periodic refresh
- Run the full refresh only after D or when serial is idle, so incoming
data is not lost while the redraw blocks
- Put the boot refresh measurement behind MEASURE_REFRESH
- Fix DEBUG hex output and use F() strings to save RAM
- Driver: direct mode now updates the old buffer instead of re-setting
the new one
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Shared BROSE9323 driver in lib/, ESPSERIAL selected via build_flags
- Nano firmware in src/nano, ESP32 firmware in src/esp32
- Move WiFi/MQTT credentials to gitignored secrets.h (template provided)
- Pin home-assistant-integration to 2.1.0 from the registry
- Add esp32_usb environment for first flash / recovery
- Add READMEs and CLAUDE.md
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
mangavalkandClaude Opus 5.5