remote_v2.scad: a new remote for the same electronics, 216 x 116 x 32 mm, ASA, two shells printed without supports and joined with M3 heat-set inserts. Hangs level from a neck strap on a balance-point eyelet (top face or front edge) with a fold-out body brace; kickstand for the table. JH-D300X-R1 sticks clamp the plate; main perfboard (Teensy 4.0, nRF24, IMU) clamped at its sides under the display; UPS board with its LEDs through the floor. Red honeycomb and white ON/OFF inlays in the first 3 layers. Every part checked for collisions. - stl/remote_v2/: print-ready STLs, plus a multi-part 3MF (export_3mf.py) with the inlays on filaments 2 and 3 - ARCHIVE.md: the original remote with the owner's photos; README shows v2 and how to print it - Notes for later: battery-voltage reading, IMU on Wire (18/19) with two stick axes moved to A7/A8, a stable 6 V supply for the 18 servos - remote.scad: its sticks are JH-D300X-R1 (the model uses the D400X drawing) - *.3mf through Git LFS; repo README says Teensy 4.0 remote Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
60 KiBLFS
60 KiBLFS