remote_v2.scad: a new remote for the same electronics, 216 x 116 x 32 mm, ASA, two shells printed without supports and joined with M3 heat-set inserts. Hangs level from a neck strap on a balance-point eyelet (top face or front edge) with a fold-out body brace; kickstand for the table. JH-D300X-R1 sticks clamp the plate; main perfboard (Teensy 4.0, nRF24, IMU) clamped at its sides under the display; UPS board with its LEDs through the floor. Red honeycomb and white ON/OFF inlays in the first 3 layers. Every part checked for collisions. - stl/remote_v2/: print-ready STLs, plus a multi-part 3MF (export_3mf.py) with the inlays on filaments 2 and 3 - ARCHIVE.md: the original remote with the owner's photos; README shows v2 and how to print it - Notes for later: battery-voltage reading, IMU on Wire (18/19) with two stick axes moved to A7/A8, a stable 6 V supply for the 18 servos - remote.scad: its sticks are JH-D300X-R1 (the model uses the D400X drawing) - *.3mf through Git LFS; repo README says Teensy 4.0 remote Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
1.8 KiB
1.8 KiB
Archive: earlier designs
Designs that are no longer the current ones, kept for reference. The
current remote is remote_v2.scad (see ../../README.md).
Original remote (remote.scad)
The remote used with the robot until 2026: a 208 x 175 x 45 mm box printed
from the Fusion 360 design ../fusion360/remote/remote v40.f3d.
remote.scad rebuilds it from that file's solids (details, and the bugs
fixed in the rebuild, in PLANNING.md, section "Remote").
What's inside (from the owner and the photos below):
- Two joysticks, JH-D300X-R1 (3-axis twist grip), on the lid. The model uses the similar JH-D400X-R4 drawing.
- Nextion NX4832T035 3.5" display under a window in the lid.
- A Teensy 4.0 socketed on a cut perfboard with the nRF24L01 (100 uF cap) and an AMS1117 regulator.
- An MPU6050 (GY-521) on the big standoff in the middle.
- An 18650 UPS/boost board on two standoffs, with its charge and on LEDs visible through two small slots in the floor.
- A USB-C breakout glued into the holder at the side port.
- A slide switch mounted on top of the lid, and a lanyard loop on the bump.
Photos of the printed remote, opened: original remote/.
![]() |
![]() |
![]() |
![]() |
Why it was replaced: the new remote (remote_v2.scad) is smaller
(216 x 116 x 32 mm), prints in ASA without supports, hangs level from a neck
strap (a balance-point eyelet and a body brace), and stands on a table.




