2026: remote v2 (flat console for the twist-grip sticks), STL/3MF exports, archive page
remote_v2.scad: a new remote for the same electronics, 216 x 116 x 32 mm, ASA, two shells printed without supports and joined with M3 heat-set inserts. Hangs level from a neck strap on a balance-point eyelet (top face or front edge) with a fold-out body brace; kickstand for the table. JH-D300X-R1 sticks clamp the plate; main perfboard (Teensy 4.0, nRF24, IMU) clamped at its sides under the display; UPS board with its LEDs through the floor. Red honeycomb and white ON/OFF inlays in the first 3 layers. Every part checked for collisions. - stl/remote_v2/: print-ready STLs, plus a multi-part 3MF (export_3mf.py) with the inlays on filaments 2 and 3 - ARCHIVE.md: the original remote with the owner's photos; README shows v2 and how to print it - Notes for later: battery-voltage reading, IMU on Wire (18/19) with two stick axes moved to A7/A8, a stable 6 V supply for the 18 servos - remote.scad: its sticks are JH-D300X-R1 (the model uses the D400X drawing) - *.3mf through Git LFS; repo README says Teensy 4.0 remote Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
e23216b3a1
commit
60605209fb
24 files changed
+918
-6
No files matched your search
@@ -17,7 +17,7 @@ named after the year it started, with its firmware, simulation, hardware, docume
|
||||
| [`2016-ssc32-processing-port/`](2016-ssc32-processing-port/) | ~2016–2018 | Arduino + SSC-32 | the Processing simulator's classes ported to Arduino, driving the SSC-32 again |
|
||||
| [`2018-unity-sim/`](2018-unity-sim/) | 2018–2023 | PC + SSC-32, later the Teensy | Unity computes the walking and drives the robot: first the SSC-32 over serial, from 2019 through the remote |
|
||||
| [`2019-teensy-nrf24/`](2019-teensy-nrf24/) | 2019–2022 | Teensy 3.6 on the robot (replaces the SSC-32), Teensy remote with Nextion screen, nRF24L01 | servo passthrough: Unity → remote over USB → radio → robot |
|
||||
| [`2026-current/`](2026-current/) | 2026– | Teensy 3.6 robot, Teensy 4.1 remote, Fusion 360 designed parts | IK, gait, body pose and IMU stabilisation on the robot; the unchanged firmware also runs inside Unity |
|
||||
| [`2026-current/`](2026-current/) | 2026– | Teensy 3.6 robot, Teensy 4.0 remote, Fusion 360 designed parts, OpenSCAD rebuild and new remote | IK, gait, body pose and IMU stabilisation on the robot; the unchanged firmware also runs inside Unity |
|
||||
|
||||
## Repository notes
|
||||
|
||||
|
||||
Reference in new issue
Block a user