2026 remote_v2 case: taller top shell, measured display, M3 display posts
- TOP_GROW: top shell 10 mm taller (room behind the display); the bottom shell is unchanged, dependent heights follow Z_SPLIT / Z_BOT. - Nextion dimensions as measured by the owner: board 100.6 x 55, LCD 85.7 x 55 x 3.86 plus a 1.3 mm flex cable, 11.21 mm glass to back of J1. LCD pocket allows the cable on either short side; bezel 1.0 mm (the display sat on the Teensy). - Display posts tapped M3 for M3 x 5 machine screws, 1.2 mm skin under the top face (was M2.5 self-tapping). README screw list and PLANNING.md updated; STLs regenerated. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
2b4750f8f4
commit
3d6c4dd2f0
6 files changed
+32
-26
No files matched your search
@@ -151,7 +151,7 @@ switch's plate sits on top of the case, body through the slot, and the old
|
||||
8 x 16 slot with d2 holes 19 mm apart fits it exactly; the UPS board's
|
||||
charge/on LEDs show through two slots in the floor.
|
||||
|
||||
- Size 216 x 116 x 32 mm (old remote: 208 x 175 x 45). Sticks at u +-80,
|
||||
- Size 216 x 116 x 42 mm (top shell 10 mm taller than first printed, TOP_GROW: room behind the display) (old remote: 208 x 175 x 45). Sticks at u +-80,
|
||||
display forward of them, strap eyelet behind the display, UPS board behind
|
||||
that, switch at the rear centre. Main board under the display.
|
||||
- JH-D300X-R1: dust cover d53.5 on the top face; the 40.4 mm control box
|
||||
@@ -160,8 +160,9 @@ charge/on LEDs show through two slots in the floor.
|
||||
towards the middle and towards the user.
|
||||
- Display mounted turned 180 deg so its J1 connector is on the right, clear
|
||||
of the Teensy's USB plug: set display direction 180 in the Nextion Editor.
|
||||
Glass 1.5 mm under the top face, board on 4 posts (M2.5 self-tapping);
|
||||
the LCD thickness (4.5) is a guess.
|
||||
Glass 1.0 mm under the top face, board on 4 posts tapped M3 (3.66 mm of thread, 1.2 mm under the top face);
|
||||
LCD 85.7 x 55 x 3.86 plus a 1.3 mm flex cable on one side, 11.21 mm glass to
|
||||
back of J1 (owner measured).
|
||||
- Main board clamped at 4 points on its long sides, no holes in the board
|
||||
(owner): posts beside the edges carry it, M3 x 8 button heads with d7
|
||||
washers in heat-set inserts clamp the edge. 2 mm above the kickstand
|
||||
|
||||
Reference in new issue
Block a user