Replace the web UI with a single-file page

The upstream jQuery page (147 KB, 3-column grid, slider values hidden,
help behind label clicks, no save feedback) is replaced by
firmware/uniclock/web/index.html: one file, no jQuery, gzipped by
web/gzip_web.py to data/index.html.gz (12 KB) before every build.

- Tabs Home / Tubes / Light / Network / System, rows with label, help
  line and control; sliders always show their value
- "Saved" / "Not saved" after each change, reverted on failure; offline
  indicator with automatic retry (the old poll stopped after one error)
- WiFi and MQTT settings only save with a Save button, then offer a
  restart; password fields are write-only
- Controls for hardware this clock lacks (alarm, radar, sensors) hidden
- Runs on sample data when opened from disk

Firmware: one serveStatic route (gzip, no-cache + ETag) replaces the
per-file routes; /getConfiguration no longer returns passwords and adds
ip, hasAlarm, hasRadar and the real cathProtMin; /getCurrentInfos adds
currentSec and mqtt state and sends "lux" instead of "lx" when there is
no sensor; /cathodeProtect and /firmwareupdate now answer.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-10-29 00:06:35 +01:00
1 parent ae87849e75
commit b40b5f680c
14 files changed
+724 -1661

No files matched your search

+2
View File
@@ -19,6 +19,8 @@ board_build.flash_mode = dio
board_build.f_cpu = 80000000L
; evaluate #ifdefs when resolving includes: the sketch includes ESP32-only libraries inside #if
lib_ldf_mode = chain+
; the web UI source is web/index.html; this writes data/index.html.gz for uploadfs
extra_scripts = pre:web/gzip_web.py
; CH340C adapter on COM7 without auto-reset: put the clock in flash mode by hand
; (hold GPIO0 to GND, tap RST, release GPIO0) before every upload/uploadfs.
upload_port = COM7