IOWarrior is the name of a series of multi-purpose USB controller chips produced and sold by Code Mercenaries. This series currently consists of three main types, that - among other features - support controlling LCD displays: IOWarrior24 USB 1.1 Low Speed 16 generic I/O Pins, typ. 125Hz read rate I2C master function, 100kHz, throughput typ. 750 bytes/sec SPI master interface, up to 2MHz, throughput typ. 750 bytes/sec control an HD44780 compatible LCD drive a matrix of up to 8x32 LEDs decode RC5 compatible infrared remote controls IOWarrior40 USB 1.1 Low Speed 32 generic I/O Pins, typ. 125Hz read rate I2C master function, 100kHz, throughput typ. 750 bytes/sec control an HD44780 compatible LCD drive a matrix of up to 8x32 LEDs drive a 8x8 switch or button matrix IOWarrior56 USB 1.1 Full Speed 50 generic I/O Pins, typ. 1000Hz read rate I2C master function, 50, 100, or 400kHz SPI master interface, up to 12MHz, throughput up to 62Kbytes/sec control various display modules, including most graphic modules drive a matrix of up to 8x64 LEDs drive a 8x8 switch or button matrix The IOWarrior driver currently only supports writing to a single-controller HD44780-type display. LED output using the output() function is also implemented, although not tested very well. The hardware's support for input using keys or IR and dual-controller displays is not implemented yet. Please note that the latter requires extra circuitry with IOWarrior24 and IOWarrior40. The driver was developed and tested with IOWarrior24 and the IOWarrior40. Although there are good chances for it to work with an IOWarrior56, the current state regarding support of this chip is unknown due to the lack of the required hardware. The driver is based on the libusb USB library, which should make it work with Linux, the different BSD variants as well as Darwin/MacOS X. When using a libusb based driver like IOWarrior, LCDd needs to be started as root. Newer Linux kernels (2.6.20 and higher) provide a kernel module iowarrior.ko that allows controlling IOWarrior chips using device files. LCDd tries to unload this kernel module for libusb to be able to control IOWarrior devices. If this fails, this may hinder LCDd from starting using the IOWarrior driver. In this case, simply unload the kernel module by hand. Size = ¶meters.size; Set the display dimensions. If not given, it defaults to 20x4. SerialNumber = SERIALNO Use the IOWarrior module with the serial number SERIALNO. If this parameter is missing, the default is to use the first IOWarrior module found. ExtendedMode = ¶meters.yesnodef; If you have a KS0073 or an other 'almost HD44780-compatible' display connected to the IOWarrior, set this flag to get into extended, 4-line linear addressing mode Lastline = ¶meters.yesdefno; Specifies if the last line is pixel addressable or it controls an underline effect. The default yes means, it is pixel addressable.