mangavalkandClaude Opus 5.5
9dc733b5bb
- RESUME is defined only in print/pause_resume.cfg; heat_soak.cfg's duplicate replaced it (no unretract, no fan restore). It now runs HEAT_SOAK_RESUME -> _RESUME_PRINT -> RESUME_BASE. - PAUSE runs PAUSE_BASE first, then retracts and parks once (X20 Y345); a parked flag makes resume undo only what PAUSE did. - New _PRINT_CLEANUP shared by PRINT_END and CANCEL_PRINT: heaters incl. iHEATER_OFF, fan, M221 S100, bdwidth off, mesh and skew cleared. In PRINT_END it runs after RESTORE_GCODE_STATE so the flow reset sticks. - Add CLAUDE.md and tools/effective_config.py. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
46 lines
1.4 KiB
INI
46 lines
1.4 KiB
INI
#####################################################################
|
|
# klipper-macros: include this one file from printer.cfg, after
|
|
# [include mainsail.cfg] (it needs [pause_resume], [virtual_sdcard] and
|
|
# [respond] from there, and replaces Mainsail's PAUSE/RESUME/CANCEL_PRINT):
|
|
#
|
|
# [include klipper-macros/klipper-macros.cfg]
|
|
#
|
|
# Comment out what you do not use. Every macro is defined in exactly one
|
|
# file: Klipper merges sections with the same name and the last one wins.
|
|
#####################################################################
|
|
|
|
[include save_variables.cfg] # the one [save_variables] for all macros
|
|
|
|
# Blobifier purge bucket (Turtleblobifier for AFC, modified)
|
|
[include blobifier/blobifier.cfg]
|
|
|
|
# Printing
|
|
[include print/pause_resume.cfg]
|
|
[include print/filament.cfg]
|
|
[include print/homing.cfg]
|
|
[include print/idle_timeout.cfg]
|
|
[include print/print_start_end.cfg]
|
|
|
|
# Heating
|
|
[include heating/bed_fans.cfg]
|
|
[include heating/chamber_iheater.cfg]
|
|
[include heating/heat_soak.cfg]
|
|
[include heating/soak_my_bed.cfg]
|
|
[include heating/filament_drying.cfg]
|
|
|
|
# AFC (Box Turtle)
|
|
[include afc/xy_safety_check.cfg]
|
|
[include afc/lane_tools.cfg]
|
|
[include afc/purge_check.cfg]
|
|
[include afc/purge_until_empty.cfg]
|
|
|
|
# Pressure advance per lane/spool (bd_pressure + Spoolman)
|
|
[include pressure_advance/bd_pa_spoolman.cfg]
|
|
|
|
# Spoolman
|
|
[include spoolman/active_spool.cfg]
|
|
|
|
# LEDs and sensors
|
|
[include leds/stealthburner_leds.cfg]
|
|
[include sensors/motion_sensor.cfg]
|