# PIR motion sensor (AM312): case light and nozzle LEDs while someone is near # # Handled by extras/motion_lights.py, outside the G-code queue: the lights # react at once, also during heat waits, AFC loads and other long commands # (with [gcode_button] they waited for those to finish). # # The AM312 keeps its output on as long as it sees movement. The timeout # starts when the motion stops, so the lights stay on while someone works at # the printer. # # someone near: case light near_value, nozzle LEDs white # nobody near, print/pause: case light print_value, nozzle LEDs off # nobody near, idle: case light idle_value, nozzle LEDs off, # logo and Box Turtle logo dim (_STATUS ready) # # CASELIGHT MODE=ON [VALUE=0.5] | OFF | AUTO overrides the sensor until the # next Klipper restart; CASELIGHT alone shows the state. _LIGHTS_ON turns the # lights on as if someone walked by (print start and end, resume). # MOTION_LIGHTS_DEBUG ENABLE=1 reports every change in the console. Setting # the case light in Mainsail lasts until the next change. [motion_lights] pin: !PC0 light: caselight nozzle_effect: sb_nozzle_light timeout: 60 # s without motion before the lights dim or turn off near_value: 1.0 # case light while someone is near print_value: 0.1 # case light while printing or paused, nobody near idle_value: 0.0 # case light while idle, nobody near on_value: 1.0 # case light for CASELIGHT MODE=ON fade_time: 0.5 # nozzle LED fade (s), same as _STATUS fade_time status_gcode: _STATUS # night mode of the logo when nobody is near