Motion lights outside the G-code queue (extras/motion_lights.py)
The AM312 case light and nozzle LEDs waited for long commands (heat waits, AFC loads, QGL) because [gcode_button] runs through the G-code queue. The new module reads the pin itself, keeps the timeout on a reactor timer and sets the case light with output_pin's send_async_request and the nozzle LEDs directly on the led_effect object. CASELIGHT and _LIGHTS_ON keep working; _STATUS_SHOW reads printer.motion_lights.near. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
55b04a7cef
commit
f25f348d0b
4 files changed
+269
-100
No files matched your search
@@ -48,7 +48,7 @@ everything below, grouped by topic. Comment out what you do not use there.
|
||||
| **leds/** | | |
|
||||
| `stealthburner_leds.cfg` | Stealthburner logo status (`_STATUS STATE=...`: heating and print progress as a filling logo, paused, error flash from `_ERROR`, part ready once the bed is cool, dim when idle and nobody is near) and the nozzle light | `led_effect`, `neopixel:bt_logo` and `rainbow_turtle` from AFC |
|
||||
| **sensors/** | | |
|
||||
| `motion_sensor.cfg` | PIR motion sensor: case light and nozzle LEDs on while someone is near (timeout from the last motion), `CASELIGHT MODE=AUTO\|ON\|OFF` | sensor on a pin, `[output_pin caselight]`, `leds/stealthburner_leds.cfg` |
|
||||
| `motion_sensor.cfg` | PIR motion sensor: case light and nozzle LEDs on while someone is near (timeout from the last motion), `CASELIGHT MODE=AUTO\|ON\|OFF`; runs outside the G-code queue, so the lights also react during heat waits and AFC loads | `extras/motion_lights.py`, sensor on a pin, `[output_pin caselight]`, `leds/stealthburner_leds.cfg` |
|
||||
|
||||
### Klipper modules (`extras/`)
|
||||
|
||||
|
||||
Reference in new issue
Block a user