MCU firmware: aldis as a submodule, old Klipper update script archived
aldis (https://github.com/mjonuschat/aldis, GPL-3.0) replaces scripts/update_all_mcus.sh: it discovers the MCUs from Moonraker and builds and flashes only outdated ones with the Kconfig each MCU reports. Its source is a submodule in external/aldis pinned to v0.4.0, the release installed on the Pi in ~/aldis (Moonraker does not fetch submodules, so it stays empty there). The old script moves to scripts/archive/; the Katapult script stays, aldis does not update bootloaders. scripts/README.md: install, setup, use and the checks for this printer (all MCUs report mcu_kconfig, all use Katapult). README and CLAUDE.md point to it. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
d8392a81c7
commit
bcb1a53b2a
6 files changed
+81
-10
No files matched your search
@@ -39,7 +39,11 @@ detection, `filament_error_sensitivity`), iHeater chamber heater.
|
||||
On the Pi, `macros/` is linked as `~/printer_data/config/klipper-macros/`
|
||||
and `scripts/` as `~/printer_data/config/klipper-macros-scripts/`.
|
||||
- `extras/*.py` are linked into `~/klipper/klippy/extras/`.
|
||||
- `scripts/` MCU firmware update scripts (printer-specific IDs) and
|
||||
- MCU firmware: aldis (`external/aldis`, git submodule pinned to the release in
|
||||
use, v0.4.0; the Pi runs the released binary in `~/aldis`). Bump the
|
||||
submodule when the Pi's aldis is updated.
|
||||
- `scripts/` Katapult update script (printer-specific IDs), the archived Klipper
|
||||
update script in `scripts/archive/`, and
|
||||
`twist_check.py` (axis twist calibration, runs on the Pi and talks to
|
||||
Moonraker on localhost; started by `TWIST_CALIBRATE` in
|
||||
`macros/calibration/twist_check.cfg`, results in `config/twist_data/`).
|
||||
|
||||
Reference in new issue
Block a user