TWIST_CALIBRATE: axis twist calibration from Mainsail
scripts/twist_check.py runs on the Pi and measures or verifies the nozzle vs Beacon offset; windows explain each step, show progress and give a verdict, with an HTML report in config/twist_data/. It refuses to start during a print, stops on unexpected readings and never changes printer.cfg. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
2c1fd27dc6
commit
92d86d6bfd
6 files changed
+852
-2
No files matched your search
@@ -51,6 +51,9 @@ everything below, grouped by topic. Comment out what you do not use there.
|
||||
| `motion_sensor.cfg` | PIR motion sensor: case light and nozzle LEDs on while someone is near (timeout from the last motion), `CASELIGHT MODE=AUTO\|ON\|OFF`; runs outside the G-code queue, so the lights also react during heat waits and AFC loads | `extras/motion_lights.py`, sensor on a pin, `[output_pin caselight]`, `leds/stealthburner_leds.cfg` |
|
||||
| `touch_compare.cfg` | `[bdp_touch]`, `TOUCH_COMPARE [N=10] [X] [Y] [TEMP=150]`: nozzle to 150C, `HOME`, then N pairs of a Beacon contact probe and a bd_pressure touch at one spot; reports mean, spread and range of each and of the difference | `extras/bdp_touch.py` + bd_pressure load-check firmware, Beacon |
|
||||
|
||||
| **calibration/** | | |
|
||||
| `twist_check.cfg` + `scripts/twist_check.py` | `TWIST_CALIBRATE`: axis twist calibration from Mainsail with windows that explain each step. Measure (25 min) says whether new `[axis_twist_compensation]` values are needed, Verify (17 min) checks them with bd_pressure. Progress on the status line, result in a window, HTML report with charts in `config/twist_data/`. Never changes `printer.cfg`. `TWIST_STOP` stops a run. | Beacon, `[axis_twist_compensation]`, `gcode_shell_command`, Mainsail prompts; Verify also `bdp_touch.py` |
|
||||
|
||||
### Klipper modules (`extras/`)
|
||||
|
||||
| File | For |
|
||||
@@ -65,7 +68,8 @@ everything below, grouped by topic. Comment out what you do not use there.
|
||||
|
||||
Firmware update scripts for all MCUs (Klipper and Katapult). They contain
|
||||
this printer's CAN UUIDs and serial IDs: see [scripts/README.md](scripts/README.md)
|
||||
before using them on another printer.
|
||||
before using them on another printer. `twist_check.py` is the axis twist
|
||||
calibration behind `TWIST_CALIBRATE`.
|
||||
|
||||
### Tools (`tools/`)
|
||||
|
||||
|
||||
Reference in new issue
Block a user