Auto-resume after an AFC buffer fault pause

A NOT FEEDING / CLOG pause during a print runs RESUME by itself after 5 s,
so the lane check and the purge check decide; a failed check keeps the print
paused. At most 2 per print, none within 10 min of printing of the previous
one, only between _PRINT_START_FINISH and the print end.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-11-08 01:39:15 +01:00
1 parent bcb1a53b2a
commit 5e8743c33a
5 files changed
+119 -1

No files matched your search

+1
View File
@@ -39,6 +39,7 @@ everything below, grouped by topic. Comment out what you do not use there.
| `lane_tools.cfg` | `LANE_FEED_UNTIL_HUB_OPEN`, `LANE_FEED_ABORT` | AFC |
| `purge_check.cfg` | `BLOBIFIER_CHECKED`: checks every AFC purge with bd_pressure (and optionally bdwidth motion); a bd_pressure that does not answer fails the check, `PURGE_CHECK_IGNORE_SENSOR` lets the current print finish without it; when the previous filament (saved `nozzle_last_temp`) needs more than 10°C above the new one, the purge runs at the previous filament's temperature and the nozzle cools back afterwards, so its leftover melts out | Blobifier, AFC, `bdpressure_check.py` from the bd_pressure repo + its load-check firmware, `extras/bdwidth_status.py` |
| `flex_lanes.cfg` | Lanes holding TPU/TPE (material from Spoolman) get slower long moves (50 mm/s, AFC's minimum) through the tube; back to the configured speed when the lane holds something else. Polls every 5 s, reapplies after a restart. The last stretch into the extruder (`tool_load_speed`) stays as configured | AFC |
| `auto_resume.cfg` | After an AFC buffer fault pause ("AFC NOT FEEDING", "CLOG DETECTED") during a print, runs `RESUME` by itself after 5 s, so the lane check and the purge check decide; a failed check keeps it paused. At most 2 per print and none within 10 min of printing after the previous one; not during `PRINT_START` or a PA test. Off: `enabled` in `_AUTO_RESUME_CFG` | `print/pause_resume.cfg`, `purge_check.cfg`, AFC |
| `purge_until_empty.cfg` | `PURGE_UNTIL_EMPTY`: purges a snapped filament out until there is no more nozzle pressure | same as `purge_check.cfg` |
| **pressure_advance/** | | |
| `bd_pressure.cfg` | `[bdpressure bd_pa]` (I2C on the Nitehawk) and the vendor macros `PA_CALIBRATE`, `PA_E`, `PA_RESET`, `PA_STATE`; `PA_CALIBRATE` no longer sets Z back to a value read before the test (wrong after a Z hop in `G28 XY`) | `bdpressure.py` from the bd_pressure repo |