Bed fans off during prints without a heated chamber, remove unused bed PID
With the chamber open the bed fans only blow room air past the bed. PRINT_WARMUP sets print_fans_off for CHAMBER 30 or less, _PRINT_CLEANUP clears it. Chamber prints, the cooldown and heating the bed outside a print are unchanged. The PID values in PRINT_WARMUP never took effect: the SET_HEATER_TEMPERATURE override in bed_fans.cfg only passes on the target. The bed keeps its config values; the misleading console messages are gone. Tested with rendered macros only, not yet on the printer. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
99b7109b5b
commit
1dcbc50bf6
3 files changed
+24
-17
No files matched your search
@@ -31,7 +31,7 @@ everything below, grouped by topic. Comment out what you do not use there.
|
||||
| **heating/** | | |
|
||||
| `heat_soak.cfg` | `HEAT_SOAK`, `STOP_HEAT_SOAK`, `CANCEL_HEAT_SOAK`, `HEAT_SOAK_RESUME`, `RESUME` | — |
|
||||
| `soak_my_bed.cfg` | `SOAK_MY_BED` (homes and levels first) | soak-my-bed |
|
||||
| `bed_fans.cfg` | Bed fans through `SET_HEATER_TEMPERATURE`/`M190`/`M140`/`TURN_OFF_HEATERS` overrides | `[fan_generic BedFans]` |
|
||||
| `bed_fans.cfg` | Bed fans through `SET_HEATER_TEMPERATURE`/`M190`/`M140`/`TURN_OFF_HEATERS` overrides; off during a print without a heated chamber (`PRINT_WARMUP CHAMBER=` 30 or less), on during the cooldown after any print | `[fan_generic BedFans]` |
|
||||
| `chamber_iheater.cfg` | iHeater MCU, heater and sensors, `M141`, `M191`, `iHEATER_ON`, `iHEATER_OFF` | iHeater chamber heater |
|
||||
| `filament_drying.cfg` | `START_DRYING`, `STOP_DRYING`, `STATUS_DRYING` | bed fans, chamber heater (optional) |
|
||||
| **afc/** | | |
|
||||
|
||||
Reference in new issue
Block a user