Bed soak on bed_side with a minimum time (measured)

Beacon meshes every 3 min on 2026-11-02 showed the 10 mm plate settles
~33 min after the bed reaches 100C with the chamber at 50C, and ~11 min at
60C with the chamber open. The old soak ended far earlier (bed_core within
5C, or the chamber reaching its target). HEAT_SOAK gets MIN_TIME=<minutes>
(default 0); PRINT_WARMUP soaks on bed_side with RATE 0.05 over 120 s,
SOAK_TEMP 70% of the bed target, MIN_TIME 35 (chamber) / 12 (no chamber),
and skips the soak without a bed target.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-11-02 16:58:20 +01:00
1 parent f25f348d0b
commit 13e49e43c7
2 files changed
+31 -9

No files matched your search

+19 -5
View File
@@ -68,14 +68,28 @@ gcode:
{% endif %}
{% if target_chamber > 30 %}
RESPOND MSG="waiting for chamber temperature"
RESPOND MSG="soaking the bed (chamber heating)"
M141 S{target_chamber}
M106 S255
# Unreachable SOAK_TEMP + CANCEL='_NOTHING': soaks until the TIMEOUT, then continues the print
HEAT_SOAK HEATER='heater_bed' TARGET={target_bed} SOAKER='temperature_sensor chamber' SOAK_TEMP={target_chamber} TIMEOUT=60 CANCEL='_NOTHING'
{% else %}
RESPOND MSG="waiting for bed core temperature"
HEAT_SOAK HEATER='heater_bed' TARGET={target_bed} SOAKER='temperature_sensor bed_core' SOAK_TEMP={target_bed - 5} TIMEOUT=30 CANCEL='_NOTHING'
RESPOND MSG="soaking the bed"
{% endif %}
# Soak until the 10 mm plate has its final shape. Measured 2026-11-02
# (Beacon mesh every 3 min, tools/soak_run.py in the 3d printer folder):
# bed 100C + chamber 50C settles ~33 min after the bed reaches target,
# bed 60C with the chamber open ~11 min. bed_core reaches target long
# before that, and swings with the PID cycle; bed_side (back edge) rises
# until the plate is settled. MIN_TIME covers the measured time, RATE
# makes a slower day (cold room) wait longer, SOAK_TEMP (70% of the bed
# target) only keeps it from ending while the bed still heats.
# CANCEL='_NOTHING': after TIMEOUT the print continues. No soak without
# a bed target (nothing to soak, MIN_TIME would only wait).
{% set soak_floor = (target_bed * 0.7) | round(1) %}
{% if target_bed <= 0 %}
{% elif target_chamber > 30 %}
HEAT_SOAK HEATER='heater_bed' TARGET={target_bed} SOAKER='temperature_sensor bed_side' SOAK_TEMP={soak_floor} RATE=0.05 RATE_SMOOTH=120 MIN_TIME=35 TIMEOUT=60 CANCEL='_NOTHING'
{% else %}
HEAT_SOAK HEATER='heater_bed' TARGET={target_bed} SOAKER='temperature_sensor bed_side' SOAK_TEMP={soak_floor} RATE=0.05 RATE_SMOOTH=120 MIN_TIME=12 TIMEOUT=30 CANCEL='_NOTHING'
{% endif %}
# With the chamber heated, filament in the toolhead path softens: a PLA lane