Name the alarm sounds

Replace Sound 1 to 7 with the names identified by ear on this lamp.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

CLAUDE.md

@@ -8,6 +8,7 @@ ESPHome firmware for a Moes Wake Up Light II (Tuya PID `ya39qahrcdhvxowz`), runn
 - `alarm_block.yaml`: controls for one alarm, included 4 times.
 - `alarm_day.yaml`: one weekday switch, included 7 times per alarm.
 - `components/uart`: ESPHome 2026.10.2's UART component with `patches/wbr3-pa13-pa14-uart.patch` applied. Recheck it when ESPHome updates.
+
 - `server-example.yaml`: the short YAML that goes on an ESPHome server.
 - `secrets.yaml`: local only, ignored by git. Needs `wifi_ssid`, `wifi_password`, `ap_password`, `api_encryption_key`.
 
@@ -64,7 +65,7 @@ From Tuya's definition for a sibling product (tuya-local issue #3821). See the R
 - Byte 11: above 1 becomes 1.
 - Byte 4 is the ring length in minutes: set to 10, a ring ran from 18:16 to 18:26 and the owner saw it stop.
 - Sound 0 is silent. In Sound + Light mode, the light still came on and no sound played.
-- Sound names, being tested one at a time: Sound 1 is birds chirping. Sounds 2 to 7 are still to do, then the names go into the sound selects.
+- Alarm sounds, identified by ear: 1 birds chirping, 2 beach (water and birds), 3 galaxy twinkles, 4 piano and birds, 5 happy harp or high piano, 6 old mechanical alarm clock, 7 old digital alarm clock. Names are in `alarm_block.yaml`. Sunset's sounds 1 to 4 haven't been checked, so they keep their numbers.
 - Radio Volume and station writes are ignored with the radio off. With it on, both work, and the station stays selected after turning it off.
 - Keep `default_transition_length` at 0. A transition sends about 50 MCU writes a second.
 - LibreTiny before v1.14.0 can hang after a software restart or OTA until powered off for about 30 seconds (LibreTiny issue #396). The config pins v1.14.0. Drop the pin once ESPHome defaults to it or newer.