From 09523be12dfc8287b500c9dfecc68fd2dd3ad0c7 Mon Sep 17 00:00:00 2001 From: MangaValk Date: Sun, 1 Nov 2026 16:35:55 +0100 Subject: [PATCH] Case: 12 inserts, M3x6 for the display Co-Authored-By: Claude Opus 5.5 --- case/README.md | 4 ++-- case/vfd-case.scad | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/case/README.md b/case/README.md index cb3a13a..3356eef 100644 --- a/case/README.md +++ b/case/README.md @@ -27,13 +27,13 @@ works if the case stays out of the sun. ## Hardware -- 10 × M3 heat-set inserts (about 4.6 mm OD, 5.7 mm long; the holes are 4.0 mm +- 12 × M3 heat-set inserts (about 4.6 mm OD, 5.7 mm long; the holes are 4.0 mm and 6 mm deep): - 4 in the bezel's display bosses - 2 in the bezel's feet - 2 in the body's rear corners - 4 on the base's board standoffs -- 4 × M3×8 to bolt the display to the bezel +- 4 × M3×6 to bolt the display to the bezel - 4 × M3×6 to hold the D1 board on its standoffs - 4 × M3×8 to hold the base on, from below; **M3×10** with the TPU feet diff --git a/case/vfd-case.scad b/case/vfd-case.scad index 271ba7f..be6fd31 100644 --- a/case/vfd-case.scad +++ b/case/vfd-case.scad @@ -8,7 +8,7 @@ // Assembly: // 1. Melt M3 heat-set inserts into: 4 display bosses + 2 feet on the bezel, // 2 rear corner bosses in the body, 4 board standoffs on the base. -// 2. Bolt the display to the bezel from behind (4x M3x8). +// 2. Bolt the display to the bezel from behind (4x M3x6). // 3. Screw the D1 board onto the base (4x M3x6). // 4. Slide the bezel (with display) up into the body's side grooves from below. // 5. Wire up, put the body on the base and screw it together from below (4x M3x8).