mangavalkandClaude Opus 5.5
dbc1f0041f
- Design docs: 12 V DC power supply, safety and bring-up, ESP32 interface, BOM - PSU schematic (schemdraw) and KiCad 10 carrier-board project with HV net classes - ESP32 PlatformIO firmware skeleton with HV watchdog toggle - Reference schematic of the Stern 520-5138-00 display PSU Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
1.3 KiB
1.3 KiB
ESP32 interface
Board: Wemos D1 mini ESP32, powered from the 5 V rail.
Level shifting
The panel inputs are 5 V TTL and the ESP32 is 3.3 V. Use a 74HCT245 (HCT only, because it accepts 3.3 V inputs) powered from 5 V, with DIR tied high (A→B) and OE tied low.
Pin plan
| Signal (to panel, through 74HCT245) | GPIO | Notes |
|---|---|---|
| Dot clock | 18 | VSPI SCK |
| Serial dot data | 23 | VSPI MOSI |
| Column latch | 17 | |
| Row data | 16 | |
| Row clock | 26 | |
| Display enable | 22 | Pull to off state at the 245 input |
| HV watchdog toggle | 21 | Charge pump → relay (see safety.md) |
| +65 V monitor (optional) | 34 | ADC, 2 × 1 MΩ + 33 kΩ divider |
The strapping pins (0, 2, 5, 12, 15) are avoided so nothing twitches during boot.
Panel data connector
- Map the panel's 14-pin data connector (signal ↔ pin) for this specific panel before wiring.
Scanning
- 128 columns × 32 rows, about 120 Hz frame rate (as on WPC).
- Per row: shift 128 bits of dot data (SPI), latch the columns, advance the row (row data is high for the first row only, then clock the row once per row).
- The panel must never sit with one row lit. Scanning runs continuously, and the HV watchdog is toggled once per scanned row (about 2 kHz, so the charge pump stays charged).