13-Dash-Mount
Dashboard holder for the JC3636W518 puck (used with 12-OBD-Speed).
Source: dash_mount.scad (OpenSCAD, all dimensions are parameters at the top). Ready STLs in stl/.
Status (2026-10-24): base printed and fits perfectly.
Parts
| Part | Print orientation | Notes |
|---|---|---|
cup.stl |
back on the bed | Snap-in cup: 0.9 mm lip over the bezel, flex slots, USB-C opening on the right (usb_angle), push-out hole in the back, hinge knuckle with detent teeth below the bottom edge |
base.stl |
foot on the bed | Flat foot 40 × 46 mm for VHB tape, two hinge ears with teeth, captive M3 nut pocket in the right ear |
knob.stl |
flat on the bed | Holds the M3 socket head (press it in warm, or glue it) |
No supports needed. ASA (dashboard heat), 0.2 mm layers, 4 perimeters (hinge strength), 30 % infill, brim/enclosure as usual for ASA.
Hardware
- M3 × 20 socket head bolt, M3 nut
- 3M VHB / double-sided foam tape for the foot
Assembly
- Press the bolt head into the knob (heat the head with a soldering iron, or add a drop of CA glue).
- Push the M3 nut into the hex pocket on the outside of the right ear.
- Put the cup's knuckle between the ears, then push the bolt through from the left and screw it into the nut.
- Snap the puck in with its USB-C port at the opening. The image orientation is set with the rotation setting in 12-OBD-Speed.
Adjusting the angle
Loosen the knob about one turn, which lets the ears spring apart so the teeth clear. Set the angle and tighten again.
The teeth lock in 10° steps (teeth = 36). The cup can tilt from about −30° (forward) to +80° (leaning back) without touching the base (checked in OpenSCAD).
Tuning
- Measure your puck with calipers and set
puck_d/puck_h.fit(0.3 mm diametral) is the clearance. - Snap too tight or too loose: change
lip(0.9) orfit. - Finer steps: raise
teeth(e.g. 48 → 7.5°), but the teeth get small and print worse. 24 gives 15° steps and is the most robust option. - Teeth too hard to clear when loosened: increase
ear_spread. If they don't lock firmly, decrease it. - Cable out on the left instead:
usb_angle = 180. part = "assembly"withtiltpreviews the mounted holder (snapped to a detent).