Files
JC3636W518EN/13-Dash-Mount/README.md
T

37 lines
2.2 KiB
Markdown
Raw Normal View History

# 13-Dash-Mount
Dashboard holder for the JC3636W518 puck (used with `12-OBD-Speed`).
Source: `dash_mount.scad` (OpenSCAD, all dimensions are parameters at the top). Ready STLs in `stl/`.
**Status (2026-10-24):** base printed and fits perfectly.
## Parts
| Part | Print orientation | Notes |
|---|---|---|
| `cup.stl` | back on the bed | Snap-in cup: 0.9 mm lip over the bezel, flex slots, USB-C opening on the right (`usb_angle`), push-out hole in the back, hinge knuckle with detent teeth below the bottom edge |
| `base.stl` | foot on the bed | Flat foot 40 × 46 mm for VHB tape, two hinge ears with teeth, captive M3 nut pocket in the right ear |
| `knob.stl` | flat on the bed | Holds the M3 socket head (press it in warm, or glue it) |
No supports needed. ASA (dashboard heat), 0.2 mm layers, 4 perimeters (hinge strength), 30 % infill, brim/enclosure as usual for ASA.
## Hardware
- M3 × 20 socket head bolt, M3 nut
- 3M VHB / double-sided foam tape for the foot
## Assembly
1. Press the bolt head into the knob (heat the head with a soldering iron, or add a drop of CA glue).
2. Push the M3 nut into the hex pocket on the outside of the right ear.
3. Put the cup's knuckle between the ears, then push the bolt through from the left and screw it into the nut.
4. Snap the puck in with its USB-C port at the opening. The image orientation is set with the rotation setting in 12-OBD-Speed.
## Adjusting the angle
Loosen the knob about one turn, which lets the ears spring apart so the teeth clear. Set the angle and tighten again.
The teeth lock in **10° steps** (`teeth = 36`). The cup can tilt from about −30° (forward) to +80° (leaning back) without touching the base (checked in OpenSCAD).
## Tuning
- **Measure your puck** with calipers and set `puck_d` / `puck_h`. `fit` (0.3 mm diametral) is the clearance.
- Snap too tight or too loose: change `lip` (0.9) or `fit`.
- Finer steps: raise `teeth` (e.g. 48 → 7.5°), but the teeth get small and print worse. 24 gives 15° steps and is the most robust option.
- Teeth too hard to clear when loosened: increase `ear_spread`. If they don't lock firmly, decrease it.
- Cable out on the left instead: `usb_angle = 180`.
- `part = "assembly"` with `tilt` previews the mounted holder (snapped to a detent).