Files
Flipdot-display/lib/BROSE9323
mangavalkandClaude Opus 5.5 8fcb17c395 Matrix refresh effect, and Random really picks from all effects
Yellow streaks fall down the columns that changed, at random moments, and
leave the new image behind them. The start ticks come from a hash, so the
only new RAM is one bit per column. Only a dot's final flip gets all pulses.

Random took micros() % 8, but micros() only gives multiples of 4 on the
Nano, so it could only pick sparkle or diagonal.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-04 02:28:34 +01:00
..

BROSE9323 driver

An Adafruit_GFX driver for Brose flipdot panels, shared by both firmware targets. The constructor is BROSE9323(width, height, panel_width, flip_time_us = 280). This project uses BROSE9323 display(84, 19, 28).

Build modes

Flag Used by Behaviour
(none) Nano Drives the panel through GPIO. Keeps an old and a new frame buffer and flips only the dots that changed.
-D ESPSERIAL ESP32 Holds no buffer. drawPixel, fillScreen, display and setTiming are sent as serial commands to the Stream passed to begin(&Serial).
-D FLIPDOT_PLCC_ADAPTER Nano (optional) Uses the pin mapping of the PLCC adapter board.

The flags are set per environment in platformio.ini through build_flags. Don't #define them in the header.

Notes

  • In direct mode (setDirect(true)) every pixel is flipped right away, without a call to display().
  • setGap(us) adds a pause after each flip pulse, setPulses(n) pulses each changed dot n times. Full redraws (display(true), the first display() after boot) pulse the dots that look unchanged only once.
  • setEffect(effect, ms): how display() shows a frame (RefreshEffect in dot_sequence.h). Anything but EFFECT_INSTANT runs in steps from update(), which must be called often; busy() says whether an effect is running. display(true) is always instant. On the ESP32 these calls become the G, N and E commands.
  • print() maps German umlauts (ÄäÖöÜüß) to the code page 437 glyphs used by the GFX font.
  • On an ATmega168 the old buffer is left out to save RAM. Every display() call then flips all dots.