Files
hexapod-robot/2026-current/hardware/openscad/ARCHIVE.md
T
mangavalkandClaude Opus 5.5 60605209fb 2026: remote v2 (flat console for the twist-grip sticks), STL/3MF exports, archive page
remote_v2.scad: a new remote for the same electronics, 216 x 116 x 32 mm,
ASA, two shells printed without supports and joined with M3 heat-set
inserts. Hangs level from a neck strap on a balance-point eyelet (top face
or front edge) with a fold-out body brace; kickstand for the table.
JH-D300X-R1 sticks clamp the plate; main perfboard (Teensy 4.0, nRF24,
IMU) clamped at its sides under the display; UPS board with its LEDs
through the floor. Red honeycomb and white ON/OFF inlays in the first
3 layers. Every part checked for collisions.

- stl/remote_v2/: print-ready STLs, plus a multi-part 3MF (export_3mf.py)
  with the inlays on filaments 2 and 3
- ARCHIVE.md: the original remote with the owner's photos; README shows v2
  and how to print it
- Notes for later: battery-voltage reading, IMU on Wire (18/19) with two
  stick axes moved to A7/A8, a stable 6 V supply for the 18 servos
- remote.scad: its sticks are JH-D300X-R1 (the model uses the D400X drawing)
- *.3mf through Git LFS; repo README says Teensy 4.0 remote

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-14 18:57:49 +01:00

1.8 KiB

Archive: earlier designs

Designs that are no longer the current ones, kept for reference. The current remote is remote_v2.scad (see ../../README.md).

Original remote (remote.scad)

The original remote, OpenSCAD model

The remote used with the robot until 2026: a 208 x 175 x 45 mm box printed from the Fusion 360 design ../fusion360/remote/remote v40.f3d. remote.scad rebuilds it from that file's solids (details, and the bugs fixed in the rebuild, in PLANNING.md, section "Remote").

What's inside (from the owner and the photos below):

  • Two joysticks, JH-D300X-R1 (3-axis twist grip), on the lid. The model uses the similar JH-D400X-R4 drawing.
  • Nextion NX4832T035 3.5" display under a window in the lid.
  • A Teensy 4.0 socketed on a cut perfboard with the nRF24L01 (100 uF cap) and an AMS1117 regulator.
  • An MPU6050 (GY-521) on the big standoff in the middle.
  • An 18650 UPS/boost board on two standoffs, with its charge and on LEDs visible through two small slots in the floor.
  • A USB-C breakout glued into the holder at the side port.
  • A slide switch mounted on top of the lid, and a lanyard loop on the bump.

Photos of the printed remote, opened: original remote/.

Lid from inside: Nextion and joysticks Bottom shell: main board, battery, IMU, USB-C
Main board, top Main board, wiring underneath

Why it was replaced: the new remote (remote_v2.scad) is smaller (216 x 116 x 32 mm), prints in ASA without supports, hangs level from a neck strap (a balance-point eyelet and a body brace), and stands on a table.