Reverse-engineered the AliExpress "USB_24RF Ver3.1" stick (STM32F030F4P6 +
Si24R1 + AT2401C PA + CH330N) and replaced its closed AT-command firmware so it
can be the PC-side radio for the hexapod.
- Pin map found over SWD and confirmed at runtime: USART1 PA9/PA10 (CH330N),
SPI1 PA5/6/7, nRF CSN PA3 / CE PA4 / IRQ PA2. LED + AT2401C control are among
the 5 free pins, still to map.
- Two-stage firmware so wire-free flashing can't be broken by an app update:
- safeboot (4 KB, pages 0-3): permanent recovery bootloader, fixed-baud flash
protocol over USB, only it survives every update;
- app (12 KB, pages 4+): the radio firmware, the only part updates rewrite.
The app updater never erases safeboot; recovery works even with a dead app.
- tools/dongle_flash.py: one-time install via the STM32 ROM bootloader (the only
time the BOOT0 wire is used). tools/safeboot_flash.py: wire-free app updates.
- dongle/README.md documents the hardware, pin map, RDP1 (factory fw can't be
dumped), the memory map and the flashing workflow.
- README: add dongle/ to the layout and the PC-radio plan.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
23 lines
742 B
C
23 lines
742 B
C
/* Startup for the stage-2 app. Polling only, so no IRQ vectors are needed
|
|
* beyond SP/Reset; safeboot jumps here directly (no M0 vector relocation). */
|
|
#include <stdint.h>
|
|
|
|
extern uint32_t _sidata, _sdata, _edata, _sbss, _ebss, _estack;
|
|
int main(void);
|
|
|
|
void Reset_Handler(void)
|
|
{
|
|
uint32_t *src = &_sidata, *dst = &_sdata;
|
|
while (dst < &_edata) *dst++ = *src++;
|
|
for (dst = &_sbss; dst < &_ebss;) *dst++ = 0;
|
|
main();
|
|
for (;;) {}
|
|
}
|
|
void Default_Handler(void) { for (;;) {} }
|
|
|
|
__attribute__((section(".isr_vector"), used))
|
|
void (*const g_vectors[])(void) = {
|
|
(void (*)(void))&_estack, Reset_Handler, Default_Handler, Default_Handler,
|
|
0, 0, 0, 0, 0, 0, 0, Default_Handler, 0, 0, Default_Handler, Default_Handler,
|
|
};
|