Files
hexapod-robot/2026-current/robot/Battery.cpp
T
mangavalkandClaude Opus 5.5 0b836af8de 2026 remote: tabbed Nextion UI, robot telemetry, servo centre calibration
Protocol v4: CmdPacket grows to 26 bytes (cal_cmd, cal_servo, cal_value);
new 30-byte Telemetry rides back on the nRF24 ack payload (robot state,
IMU, battery, 18 joint angles, packets/s, servo-cal echo). Each end drops
wrong-length packets, so version mismatches still fail closed.

Robot (owner-approved): SERVO_CAL state while disarmed, per-servo centre
trims (+-200 us) in EEPROM, telemetry, battery reading; the IMU estimate
now always runs (leveling still gated by ROBOT GYRO).

Remote: generated HMI (scripts/make_remote_hmi.py) with pages splash,
drive, status, servos, cal, setup, upload; page-aware NextionUI that only
writes the showing page and only what changed; servo calibration and
UPDATE DISPLAY on the touchscreen and serial console; battery module.
The display is on Serial2 (pins 7/8), found on the real remote; the old
sketch's Serial1 was never connected to it.

Sim: RF24 shim supports ack payloads, API version 8
(hxsim_get_ack_payload); sim_smoke checks telemetry and every CAL command.
Unity CmdPacket mirror updated.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-17 14:42:37 +01:00

11 lines
435 B
C++

#include "Battery.h"
#include "Config.h"
void Battery::update(float dt) {
if (BATTERY_SENSE_PIN == 255) return; // not fitted: stays 0
float v = analogRead(BATTERY_SENSE_PIN) * (BATTERY_ADC_REF_V / BATTERY_ADC_MAX) * BATTERY_DIVIDER;
if (!primed_) { volts_ = v; primed_ = true; return; }
float a = constrain(dt / 2.0f, 0.0f, 1.0f); // ~2 s time constant: servo load makes it sag and bounce
volts_ += (v - volts_) * a;
}