# Archive: earlier designs Designs that are no longer the current ones, kept for reference. The current remote is `remote_v2.scad` (see [../../README.md](../../README.md)). ## Original remote (`remote.scad`) ![The original remote, OpenSCAD model](renders/remote.png) The remote used with the robot until 2026: a 208 x 175 x 45 mm box printed from the Fusion 360 design `../fusion360/remote/remote v40.f3d`. `remote.scad` rebuilds it from that file's solids (details, and the bugs fixed in the rebuild, in [PLANNING.md](PLANNING.md), section "Remote"). What's inside (from the owner and the photos below): - Two joysticks, JH-D300X-R1 (3-axis twist grip), on the lid. The model uses the similar JH-D400X-R4 drawing. - Nextion NX4832T035 3.5" display under a window in the lid. - A Teensy 4.0 socketed on a cut perfboard with the nRF24L01 (100 uF cap) and an AMS1117 regulator. - An MPU6050 (GY-521) on the big standoff in the middle. - An 18650 UPS/boost board on two standoffs, with its charge and on LEDs visible through two small slots in the floor. - A USB-C breakout glued into the holder at the side port. - A slide switch mounted on top of the lid, and a lanyard loop on the bump. Photos of the printed remote, opened: [original remote/](original%20remote/). | | | |---|---| | ![Lid from inside: Nextion and joysticks](original%20remote/20261114_175520.jpg) | ![Bottom shell: main board, battery, IMU, USB-C](original%20remote/20261114_175548.jpg) | | ![Main board, top](original%20remote/20261114_175504.jpg) | ![Main board, wiring underneath](original%20remote/20261114_175509.jpg) | Why it was replaced: the new remote (`remote_v2.scad`) is smaller (216 x 116 x 32 mm), prints in ASA without supports, hangs level from a neck strap (a balance-point eyelet and a body brace), and stands on a table.