Commit Graph
2 Commits
Author SHA1 Message Date
mangavalkandClaude Opus 5.5 3d6c4dd2f0 2026 remote_v2 case: taller top shell, measured display, M3 display posts
- TOP_GROW: top shell 10 mm taller (room behind the display); the bottom
  shell is unchanged, dependent heights follow Z_SPLIT / Z_BOT.
- Nextion dimensions as measured by the owner: board 100.6 x 55, LCD
  85.7 x 55 x 3.86 plus a 1.3 mm flex cable, 11.21 mm glass to back of J1.
  LCD pocket allows the cable on either short side; bezel 1.0 mm (the
  display sat on the Teensy).
- Display posts tapped M3 for M3 x 5 machine screws, 1.2 mm skin under the
  top face (was M2.5 self-tapping). README screw list and PLANNING.md
  updated; STLs regenerated.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-17 22:50:48 +01:00
mangavalkandClaude Opus 5.5 60605209fb 2026: remote v2 (flat console for the twist-grip sticks), STL/3MF exports, archive page
remote_v2.scad: a new remote for the same electronics, 216 x 116 x 32 mm,
ASA, two shells printed without supports and joined with M3 heat-set
inserts. Hangs level from a neck strap on a balance-point eyelet (top face
or front edge) with a fold-out body brace; kickstand for the table.
JH-D300X-R1 sticks clamp the plate; main perfboard (Teensy 4.0, nRF24,
IMU) clamped at its sides under the display; UPS board with its LEDs
through the floor. Red honeycomb and white ON/OFF inlays in the first
3 layers. Every part checked for collisions.

- stl/remote_v2/: print-ready STLs, plus a multi-part 3MF (export_3mf.py)
  with the inlays on filaments 2 and 3
- ARCHIVE.md: the original remote with the owner's photos; README shows v2
  and how to print it
- Notes for later: battery-voltage reading, IMU on Wire (18/19) with two
  stick axes moved to A7/A8, a stable 6 V supply for the 18 servos
- remote.scad: its sticks are JH-D300X-R1 (the model uses the D400X drawing)
- *.3mf through Git LFS; repo README says Teensy 4.0 remote

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-14 18:57:49 +01:00