- Confirmed the status LED is on PA0 (active-high). README pin table updated:
amplifier (AT2401C) control is one of PA1/PB1/PF0/PF1, still to distinguish.
- app.c gains bring-up modes for mapping the amplifier pins:
- 'x' RX on the hexapod protocol (ch96/250k/HXPD1, 22-byte) + packet counter,
to find the RX-enable pin by which pin lets the remote's packets arrive;
- 'f'/'n' carrier-detect (RPD) finder (too noisy alone, kept for reference);
- 'a' sweep every usable pin HIGH ~3s for LED/scope checks.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- dongle_flash.py aborts before erasing unless the ROM-bootloader link tests
clean (8/8 GETs), so a flaky software-jump link can't wipe a working stick.
- open_racing() retries opening the port to win the race against SignalRGB,
which grabs CH340 ports on enumeration.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Reverse-engineered the AliExpress "USB_24RF Ver3.1" stick (STM32F030F4P6 +
Si24R1 + AT2401C PA + CH330N) and replaced its closed AT-command firmware so it
can be the PC-side radio for the hexapod.
- Pin map found over SWD and confirmed at runtime: USART1 PA9/PA10 (CH330N),
SPI1 PA5/6/7, nRF CSN PA3 / CE PA4 / IRQ PA2. LED + AT2401C control are among
the 5 free pins, still to map.
- Two-stage firmware so wire-free flashing can't be broken by an app update:
- safeboot (4 KB, pages 0-3): permanent recovery bootloader, fixed-baud flash
protocol over USB, only it survives every update;
- app (12 KB, pages 4+): the radio firmware, the only part updates rewrite.
The app updater never erases safeboot; recovery works even with a dead app.
- tools/dongle_flash.py: one-time install via the STM32 ROM bootloader (the only
time the BOOT0 wire is used). tools/safeboot_flash.py: wire-free app updates.
- dongle/README.md documents the hardware, pin map, RDP1 (factory fw can't be
dumped), the memory map and the flashing workflow.
- README: add dongle/ to the layout and the PC-radio plan.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>