Commit Graph
3 Commits
Author SHA1 Message Date
mangavalkandClaude Opus 5.5 0b836af8de 2026 remote: tabbed Nextion UI, robot telemetry, servo centre calibration
Protocol v4: CmdPacket grows to 26 bytes (cal_cmd, cal_servo, cal_value);
new 30-byte Telemetry rides back on the nRF24 ack payload (robot state,
IMU, battery, 18 joint angles, packets/s, servo-cal echo). Each end drops
wrong-length packets, so version mismatches still fail closed.

Robot (owner-approved): SERVO_CAL state while disarmed, per-servo centre
trims (+-200 us) in EEPROM, telemetry, battery reading; the IMU estimate
now always runs (leveling still gated by ROBOT GYRO).

Remote: generated HMI (scripts/make_remote_hmi.py) with pages splash,
drive, status, servos, cal, setup, upload; page-aware NextionUI that only
writes the showing page and only what changed; servo calibration and
UPDATE DISPLAY on the touchscreen and serial console; battery module.
The display is on Serial2 (pins 7/8), found on the real remote; the old
sketch's Serial1 was never connected to it.

Sim: RF24 shim supports ack payloads, API version 8
(hxsim_get_ack_payload); sim_smoke checks telemetry and every CAL command.
Unity CmdPacket mirror updated.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-17 14:42:37 +01:00
mangavalkandClaude Opus 5.5 5ff85c4eb8 Robot: Teensy 3.6 with the old robot's servo wiring and calibration
- LEGACY/Hexapod_Teensy/: old robot sketch (reference only).
- platformio.ini: robot env targets teensy36 (owner-confirmed board).
- Config.h: per-servo SERVOS table (pin, pulse at 0 deg, signed
  us/deg, pulse limits) built from the old sketch's pins, ranges, trims
  and the old Unity servo directions. Rear-left/front-left coxa offsets
  set to 0: the owner re-horns those two servos (the old +-90 left them
  at the end of travel; the sim showed them clamping).
- ServoDriver: 18 servos on hardware PWM (50 Hz, 16-bit); the Teensy 3.6
  Servo library stops at 12.
- Radio on CE 39 / CSN 15 with SPI SCK on pin 14.
- sim: analogWrite/PWM shims, pulses decoded through SERVOS (API v6).
- Docs: CLAUDE.md, READMEs.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-01 15:53:55 +02:00
mangavalkandClaude Opus 5.5 ad77b06c36 Initial import: robot firmware + PlatformIO two-env scaffold
Robot-side firmware (Teensy 4.0) imported unchanged as extracted.
platformio.ini defines [env:robot] (teensy40) and [env:remote]
(teensy41); scripts/select_src_dir.py points each env at its own
sketch folder so robot/ and remote/ stay Arduino-style sketches.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-09-28 15:36:37 +02:00