2026 remote: build for the Teensy 4.0 actually in the remote
Board teensy41 -> teensy40. All pins exist on the 4.0; the MPU6050's Wire2 (SDA2 25 / SCL2 24) is on the underside solder pads. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
769d72462d
commit
e23216b3a1
7 files changed
+20
-18
No files matched your search
@@ -1,4 +1,4 @@
|
||||
# Hexapod remote firmware (Teensy 4.1)
|
||||
# Hexapod remote firmware (Teensy 4.0)
|
||||
|
||||
Handheld transmitter for the hexapod. It reads two 3-axis twist-grip
|
||||
joysticks and an MPU6050, takes operator commands from a Nextion
|
||||
@@ -13,17 +13,17 @@ From the `2026-current` folder: `pio run -e remote`, flash with
|
||||
|
||||
## Wiring (from the old remote sketch in `../../2019-teensy-nrf24/remote/`; edit `Config.h` if yours differs)
|
||||
|
||||
| Part | Signal | Teensy 4.1 pin |
|
||||
| Part | Signal | Teensy 4.0 pin |
|
||||
|------|--------|----------------|
|
||||
| nRF24L01 | MOSI / MISO / SCK | 11 / 12 / 13 (SPI0) |
|
||||
| nRF24L01 | CE / CSN | 9 / 10 |
|
||||
| nRF24L01 | VCC | 3.3 V, with a 10–100 µF cap right at the module |
|
||||
| MPU6050 | SDA / SCL | **25 / 24 (Wire2)**: not 18/19, those are stick pins A4/A5 |
|
||||
| MPU6050 | SDA / SCL | **25 / 24 (Wire2)**, solder pads on the underside of the 4.0: not 18/19, those are stick pins A4/A5 |
|
||||
| Nextion | TX → RX1, RX ← TX1 | 0 / 1 (Serial1), 5 V supply |
|
||||
| Sticks | 6 axes | A0–A5. Which axis is on which pin isn't known yet: reorder `STICK_PINS` until the `p` dump reads right |
|
||||
|
||||
**MPU6050 rewiring:** the old remote had its MPU code switched off, probably
|
||||
because A4/A5 double as Wire's pins. Move the MPU's SDA/SCL to pins 25/24.
|
||||
because A4/A5 double as Wire's pins. Move the MPU's SDA/SCL to pins 25/24 (the pads under the board).
|
||||
|
||||
Stick pots are wired 3.3 V – wiper – GND. **Never feed 5 V into a Teensy
|
||||
4.x analog pin.**
|
||||
|
||||
Reference in new issue
Block a user