2026 remote: build for the Teensy 4.0 actually in the remote
Board teensy41 -> teensy40. All pins exist on the 4.0; the MPU6050's Wire2 (SDA2 25 / SCL2 24) is on the underside solder pads. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
769d72462d
commit
e23216b3a1
7 files changed
+20
-18
No files matched your search
@@ -2,7 +2,7 @@
|
||||
#include <Arduino.h>
|
||||
|
||||
// =====================================================================
|
||||
// Remote handset config (Teensy 4.1). Everything here is a placeholder
|
||||
// Remote handset config (Teensy 4.0). Everything here is a placeholder
|
||||
// until checked against your real wiring and parts - see the BENCH notes.
|
||||
// Radio address/channel/rate/PA/payload size are NOT here: they live in
|
||||
// shared/HexapodProtocol so they can't drift from the robot.
|
||||
@@ -69,8 +69,10 @@ constexpr float STICK_EXPO[NUM_AXES] = { 0.25f, 0.25f, 0.30f, 0.20f, 0.20f,
|
||||
// One-pole low-pass on raw ADC counts (1 = no filtering). Pots are noisy.
|
||||
constexpr float STICK_FILTER_ALPHA = 0.5f;
|
||||
|
||||
// ---- Remote IMU: MPU6050 on the second I2C bus (Wire2: SDA2 = 25, SCL2 = 24) ----
|
||||
// Not Wire (18/19): those pins are stick axes A4/A5.
|
||||
// ---- Remote IMU: MPU6050 on the third I2C bus (Wire2: SDA2 = 25, SCL2 = 24) ----
|
||||
// On the Teensy 4.0, 24/25 are solder pads on the underside, not edge pins.
|
||||
// Not Wire (18/19): those pins are stick axes A4/A5. Not Wire1 (17/16) either:
|
||||
// those are stick axes A3/A2.
|
||||
#define IMU_WIRE Wire2
|
||||
constexpr uint8_t IMU_ADDR = 0x68; // 0x69 if AD0 is pulled high
|
||||
// Mounting remap: which chip axis (0=X,1=Y,2=Z) and sign gives each handset
|
||||
|
||||
Reference in new issue
Block a user