2026 remote v2: clamps for the 56x80 perfboard, generated inlay 3MF
- remote_v2.scad: main board is the measured 56 x 80 mm perfboard, held by 4 side clamps (M3 button head + washer into inserts), no holes in the board - export_3mf.py writes remote_v2_top_inlays.3mf (top shell + honeycomb + ON/OFF on filaments 1/2/3); remote_v2_top_multicolor.3mf stays the owner's OrcaSlicer project - STLs re-exported, README printing table and PLANNING notes updated Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
80270ba17e
commit
4aeb79dc89
6 files changed
+22
-16
No files matched your search
@@ -145,7 +145,7 @@ them), strap tabs at the rear corners (it tipped forward), a hexapod emblem
|
||||
inlay (owner preferred a honeycomb).
|
||||
|
||||
From the owner's photos and drawing: the sticks are JH-D300X-R1; the Teensy
|
||||
sits socketed on a cut perfboard (~52 x 80, estimated) with the nRF24L01
|
||||
sits socketed on a cut perfboard (56 x 80, measured) with the nRF24L01
|
||||
(100 uF cap), an AMS1117, the ribbon connectors and now also the GY-521; the
|
||||
switch's plate sits on top of the case, body through the slot, and the old
|
||||
8 x 16 slot with d2 holes 19 mm apart fits it exactly; the UPS board's
|
||||
@@ -197,7 +197,7 @@ charge/on LEDs show through two slots in the floor.
|
||||
- Checked: no part collides with the shells or with each other, the shells
|
||||
and the inlay don't overlap, kickstand clear at 0 and 70 deg, bail clear
|
||||
from 0 to -180 deg (CGAL intersections).
|
||||
- Open: perfboard size and holes, Teensy cable plug size, LCD thickness, UPS
|
||||
- Open: component positions on the main board, Teensy cable plug size, LCD thickness, UPS
|
||||
hole spacing; hand room untested; set `IMU_AXIS_FROM_CHIP` /
|
||||
`IMU_AXIS_SIGN` in `remote/Config.h` for the IMU on the main board.
|
||||
|
||||
|
||||
Reference in new issue
Block a user