2026 dongle: LED is PA0, add RX/finder/sweep pin-finding modes to the app
- Confirmed the status LED is on PA0 (active-high). README pin table updated:
amplifier (AT2401C) control is one of PA1/PB1/PF0/PF1, still to distinguish.
- app.c gains bring-up modes for mapping the amplifier pins:
- 'x' RX on the hexapod protocol (ch96/250k/HXPD1, 22-byte) + packet counter,
to find the RX-enable pin by which pin lets the remote's packets arrive;
- 'f'/'n' carrier-detect (RPD) finder (too noisy alone, kept for reference);
- 'a' sweep every usable pin HIGH ~3s for LED/scope checks.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
4fcf9cf3d7
commit
2a4f6335dd
2 files changed
+106
-7
No files matched your search
@@ -29,12 +29,16 @@ Found by probing the board over SWD and confirmed at runtime by our firmware:
|
||||
| USB serial (USART1) TX / RX | PA9 / PA10 → CH330N |
|
||||
| SPI1 SCK / MISO / MOSI | PA5 / PA6 / PA7 → Si24R1 |
|
||||
| nRF CSN / CE / IRQ | PA3 / PA4 / PA2 |
|
||||
| free (LED + AT2401C TX/RX enable) | PA0, PA1, PB1, PF0, PF1 — **not yet mapped** |
|
||||
| status LED (active-high) | **PA0** — confirmed by eye |
|
||||
| AT2401C TX/RX enable + unused | PA1, PB1, PF0, PF1 — **not yet distinguished** |
|
||||
|
||||
The LED and the AT2401C control lines are somewhere in those 5 free pins (the
|
||||
TSSOP-20 has no other GPIO); the app firmware toggles them one at a time so we
|
||||
can identify them by eye / by a range test. Until the PA control is known the
|
||||
radio still works, just at reduced range.
|
||||
PA0 drives the LED (HIGH = on). The AT2401C control lines are among PA1, PB1,
|
||||
PF0, PF1 (the TSSOP-20 has no other GPIO). Listening for ambient 2.4 GHz with
|
||||
the radio's carrier-detect bit was too noisy to tell them apart, so they need a
|
||||
real link test (dongle ↔ robot/remote, trying each pin while watching whether
|
||||
packets get through). The radio still works without driving the amplifier, just
|
||||
at reduced range. The app firmware can drive any pin (`0`-`4`), sweep them all
|
||||
(`a`), and run a carrier-detect finder (`f`/`n`).
|
||||
|
||||
### Programming header (5 holes next to the CH330N)
|
||||
|
||||
|
||||
Reference in new issue
Block a user