2026 docs: review of every README against today's state
- README / CLAUDE.md layout: dongle/, hardware/, tools/ submodule, make_remote_hmi.py; telemetry in the protocol; the PC can take the robot's place on the radio. CLAUDE.md: NextionUI is on Serial2 (said Serial1); remote-without-robot via the dongle + sim. - remote/README: MPU6050 supply row; stick calibration button names of the new SETUP page; upload/USB-port hints. - remote/NEXTION.md: display on Serial2, how the Editor upload goes. - robot/README: Battery in the file list, Comms/ServoDriver roles, packet structs instead of payload size, check the IMU gives live data (the remote's MPU6050 needed a full reset; RobotIMU::begin() only wakes it). - sim/README: smoke test covers telemetry and servo calibration; OpenScadModel. - dongle/README: AT2401C test result, app command table, SignalRGB note, air settings incl. ack payloads. - PLANNING.md: the display direction is in the generated HMI. - Unity README: what the project is. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
a59faf3b03
commit
179afdb705
9 files changed
+92
-33
No files matched your search
@@ -7,7 +7,14 @@ It's **generated** by `../scripts/make_remote_hmi.py`: change the layout
|
||||
there and re-run it, rather than editing the `.HMI` in Nextion Editor (an
|
||||
Editor edit is lost on the next run). Then open `remote.HMI` in Nextion
|
||||
Editor, compile, and upload the `.tft`: SETUP › UPDATE DISPLAY (tap twice)
|
||||
or serial key `U` puts the remote in USB passthrough for the upload.
|
||||
or serial key `U` puts the remote in USB passthrough for the upload. In the
|
||||
Editor, upload to the Teensy's COM port with the baud rate on auto. When the
|
||||
Editor is newer than the display's firmware, the upload first updates that
|
||||
firmware: don't interrupt it. Power-cycle the remote afterwards to leave
|
||||
upload mode.
|
||||
|
||||
The display is on the remote's **Serial2** (Teensy RX2 = pin 7, TX2 = pin 8),
|
||||
at 115200.
|
||||
|
||||
```
|
||||
python scripts\make_remote_hmi.py (from 2026-current)
|
||||
|
||||
Reference in new issue
Block a user