2026 docs: review of every README against today's state

- README / CLAUDE.md layout: dongle/, hardware/, tools/ submodule,
  make_remote_hmi.py; telemetry in the protocol; the PC can take the
  robot's place on the radio. CLAUDE.md: NextionUI is on Serial2 (said
  Serial1); remote-without-robot via the dongle + sim.
- remote/README: MPU6050 supply row; stick calibration button names of the
  new SETUP page; upload/USB-port hints.
- remote/NEXTION.md: display on Serial2, how the Editor upload goes.
- robot/README: Battery in the file list, Comms/ServoDriver roles, packet
  structs instead of payload size, check the IMU gives live data (the
  remote's MPU6050 needed a full reset; RobotIMU::begin() only wakes it).
- sim/README: smoke test covers telemetry and servo calibration;
  OpenScadModel.
- dongle/README: AT2401C test result, app command table, SignalRGB note,
  air settings incl. ack payloads.
- PLANNING.md: the display direction is in the generated HMI.
- Unity README: what the project is.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-11-17 22:56:14 +01:00
1 parent a59faf3b03
commit 179afdb705
9 files changed
+92 -33

No files matched your search

+2 -1
View File
@@ -159,7 +159,8 @@ charge/on LEDs show through two slots in the floor.
plate into the box (no nuts). Reaches 28.5 mm down. Pots (d16.5, 9.2 out)
towards the middle and towards the user.
- Display mounted turned 180 deg so its J1 connector is on the right, clear
of the Teensy's USB plug: set display direction 180 in the Nextion Editor.
of the Teensy's USB plug. `remote/remote.HMI` is generated for that
(direction 270 in the Nextion Editor's terms; done 2026-11-17).
Glass 1.0 mm under the top face, board on 4 posts tapped M3 (3.66 mm of thread, 1.2 mm under the top face);
LCD 85.7 x 55 x 3.86 plus a 1.3 mm flex cable on one side, 11.21 mm glass to
back of J1 (owner measured).