2026 remote: tabbed Nextion UI, robot telemetry, servo centre calibration
Protocol v4: CmdPacket grows to 26 bytes (cal_cmd, cal_servo, cal_value); new 30-byte Telemetry rides back on the nRF24 ack payload (robot state, IMU, battery, 18 joint angles, packets/s, servo-cal echo). Each end drops wrong-length packets, so version mismatches still fail closed. Robot (owner-approved): SERVO_CAL state while disarmed, per-servo centre trims (+-200 us) in EEPROM, telemetry, battery reading; the IMU estimate now always runs (leveling still gated by ROBOT GYRO). Remote: generated HMI (scripts/make_remote_hmi.py) with pages splash, drive, status, servos, cal, setup, upload; page-aware NextionUI that only writes the showing page and only what changed; servo calibration and UPDATE DISPLAY on the touchscreen and serial console; battery module. The display is on Serial2 (pins 7/8), found on the real remote; the old sketch's Serial1 was never connected to it. Sim: RF24 shim supports ack payloads, API version 8 (hxsim_get_ack_payload); sim_smoke checks telemetry and every CAL command. Unity CmdPacket mirror updated. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
481610c9fd
commit
0b836af8de
40 files changed
+1463
-281
No files matched your search
@@ -19,7 +19,7 @@ robot/ (unchanged) ──► PlatformIO + Teensy core ──► Teensy 3.6 firmw
|
||||
|---|---|
|
||||
| `analogWrite()` hardware PWM (how `ServoDriver` drives the servos) | the pulse width per pin, worked out from duty, resolution and frequency, then decoded back to angles through `Config.h`'s per-servo `SERVOS` table |
|
||||
| `Wire` + MPU6050 registers | a register-level fake MPU6050 at 0x68, fed from the simulated body's tilt and rotation |
|
||||
| `RF24` | a simulated radio: packets are received only if channel, address, data rate and **payload size** match, and the RX FIFO holds 3 |
|
||||
| `RF24` | a simulated radio: packets are received only if channel, address, data rate and **payload size** match (any length up to 32 once `enableAckPayload()` turns on dynamic payloads, as on the chip), and the RX FIFO holds 3. `writeAckPayload()` goes back with the next packet received: `hxsim_get_ack_payload` returns it (the robot's `Telemetry`) |
|
||||
| `millis()` / `micros()` / `Serial` | a simulated clock that Unity advances, and captured serial I/O |
|
||||
|
||||
`robot_ino.cpp` compiles `robot.ino` itself and exposes read-only views of
|
||||
|
||||
Reference in new issue
Block a user