2026 remote: tabbed Nextion UI, robot telemetry, servo centre calibration
Protocol v4: CmdPacket grows to 26 bytes (cal_cmd, cal_servo, cal_value); new 30-byte Telemetry rides back on the nRF24 ack payload (robot state, IMU, battery, 18 joint angles, packets/s, servo-cal echo). Each end drops wrong-length packets, so version mismatches still fail closed. Robot (owner-approved): SERVO_CAL state while disarmed, per-servo centre trims (+-200 us) in EEPROM, telemetry, battery reading; the IMU estimate now always runs (leveling still gated by ROBOT GYRO). Remote: generated HMI (scripts/make_remote_hmi.py) with pages splash, drive, status, servos, cal, setup, upload; page-aware NextionUI that only writes the showing page and only what changed; servo calibration and UPDATE DISPLAY on the touchscreen and serial console; battery module. The display is on Serial2 (pins 7/8), found on the real remote; the old sketch's Serial1 was never connected to it. Sim: RF24 shim supports ack payloads, API version 8 (hxsim_get_ack_payload); sim_smoke checks telemetry and every CAL command. Unity CmdPacket mirror updated. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
481610c9fd
commit
0b836af8de
40 files changed
+1463
-281
No files matched your search
@@ -140,6 +140,15 @@ constexpr uint8_t RADIO_CSN_PIN = 15;
|
||||
constexpr uint8_t RADIO_SCK_PIN = 14;
|
||||
constexpr float LINK_TIMEOUT_SEC = 0.3f;
|
||||
|
||||
// ---- Battery voltage (shown on the remote's STATUS page) ----
|
||||
// Battery + through a resistor divider into an analog pin. BENCH: no divider
|
||||
// is wired yet - set the pin and the divider ratio (battery V / pin V) once
|
||||
// it is. 255 = not fitted: the remote then shows "--".
|
||||
constexpr uint8_t BATTERY_SENSE_PIN = 255;
|
||||
constexpr float BATTERY_DIVIDER = 3.0f; // e.g. 20k over 10k
|
||||
constexpr float BATTERY_ADC_REF_V = 3.3f; // Teensy 3.6 analog reference
|
||||
constexpr int BATTERY_ADC_MAX = 1023; // default 10-bit analogRead()
|
||||
|
||||
// ---- Robot-gyro self-leveling ----
|
||||
// Integral gain (1/s): a leftover tilt of 1 deg changes the correction by
|
||||
// this many deg/s. Higher levels faster but can wobble. BENCH: tune on the robot.
|
||||
|
||||
Reference in new issue
Block a user