2026 remote: tabbed Nextion UI, robot telemetry, servo centre calibration

Protocol v4: CmdPacket grows to 26 bytes (cal_cmd, cal_servo, cal_value);
new 30-byte Telemetry rides back on the nRF24 ack payload (robot state,
IMU, battery, 18 joint angles, packets/s, servo-cal echo). Each end drops
wrong-length packets, so version mismatches still fail closed.

Robot (owner-approved): SERVO_CAL state while disarmed, per-servo centre
trims (+-200 us) in EEPROM, telemetry, battery reading; the IMU estimate
now always runs (leveling still gated by ROBOT GYRO).

Remote: generated HMI (scripts/make_remote_hmi.py) with pages splash,
drive, status, servos, cal, setup, upload; page-aware NextionUI that only
writes the showing page and only what changed; servo calibration and
UPDATE DISPLAY on the touchscreen and serial console; battery module.
The display is on Serial2 (pins 7/8), found on the real remote; the old
sketch's Serial1 was never connected to it.

Sim: RF24 shim supports ack payloads, API version 8
(hxsim_get_ack_payload); sim_smoke checks telemetry and every CAL command.
Unity CmdPacket mirror updated.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
mangavalkandClaude Opus 5.5 committed 2026-11-17 14:42:37 +01:00
1 parent 481610c9fd
commit 0b836af8de
40 files changed
+1463 -281

No files matched your search

+9
View File
@@ -23,6 +23,15 @@ bool SerialConsole::poll(UiEvent& ui, Local& local) {
case 'c': ui.cmd = UiCmd::CalStartSave; return true;
case 'x': ui.cmd = UiCmd::CalCancel; return true;
case 'U': ui.cmd = UiCmd::NextionUpload; return true;
case 'o': ui.cmd = UiCmd::ServoCalToggle; return true;
case 'n': ui.cmd = UiCmd::ServoCalNext; return true;
case ',': ui = UiEvent{ UiCmd::ServoCalTrim, SERVO_TRIM_MINUS_SMALL }; return true;
case '.': ui = UiEvent{ UiCmd::ServoCalTrim, SERVO_TRIM_PLUS_SMALL }; return true;
case '<': ui = UiEvent{ UiCmd::ServoCalTrim, SERVO_TRIM_MINUS_BIG }; return true;
case '>': ui = UiEvent{ UiCmd::ServoCalTrim, SERVO_TRIM_PLUS_BIG }; return true;
case '0': ui = UiEvent{ UiCmd::ServoCalTrim, SERVO_TRIM_ZERO }; return true;
case 'w': ui.cmd = UiCmd::ServoCalSave; return true;
case 'e': ui.cmd = UiCmd::ServoCalRevert; return true;
case 'p': local = Local::PrintStatus; return true;
case 'd': local = Local::ToggleDump; return true;
case 'R': local = Local::ResetCal; return true;