Files
hexapod-robot/2026-current/hardware/openscad/ARCHIVE.md
T

37 lines
1.8 KiB
Markdown
Raw Normal View History

# Archive: earlier designs
Designs that are no longer the current ones, kept for reference. The
current remote is `remote_v2.scad` (see [../../README.md](../../README.md)).
## Original remote (`remote.scad`)
![The original remote, OpenSCAD model](renders/remote.png)
The remote used with the robot until 2026: a 208 x 175 x 45 mm box printed
from the Fusion 360 design `../fusion360/remote/remote v40.f3d`.
`remote.scad` rebuilds it from that file's solids (details, and the bugs
fixed in the rebuild, in [PLANNING.md](PLANNING.md), section "Remote").
What's inside (from the owner and the photos below):
- Two joysticks, JH-D300X-R1 (3-axis twist grip), on the lid. The model
uses the similar JH-D400X-R4 drawing.
- Nextion NX4832T035 3.5" display under a window in the lid.
- A Teensy 4.0 socketed on a cut perfboard with the nRF24L01 (100 uF cap)
and an AMS1117 regulator.
- An MPU6050 (GY-521) on the big standoff in the middle.
- An 18650 UPS/boost board on two standoffs, with its charge and on LEDs
visible through two small slots in the floor.
- A USB-C breakout glued into the holder at the side port.
- A slide switch mounted on top of the lid, and a lanyard loop on the bump.
Photos of the printed remote, opened: [original remote/](original%20remote/).
| | |
|---|---|
| ![Lid from inside: Nextion and joysticks](original%20remote/20261114_175520.jpg) | ![Bottom shell: main board, battery, IMU, USB-C](original%20remote/20261114_175548.jpg) |
| ![Main board, top](original%20remote/20261114_175504.jpg) | ![Main board, wiring underneath](original%20remote/20261114_175509.jpg) |
Why it was replaced: the new remote (`remote_v2.scad`) is smaller
(216 x 116 x 32 mm), prints in ASA without supports, hangs level from a neck
strap (a balance-point eyelet and a body brace), and stands on a table.